M.A. Ford
M.A. Ford Twister Al 5X 3 Flute Drill No 50 part 22907000
Drills aluminium with a three-flute, five-times-diameter design in size No 50
- Three-flute design improves chip evacuation in aluminium
- 5X diameter drilling depth capability
- No 50 drill size for precise hole diameter
- M.A. Ford manufacturing quality
- California Proposition 65 chemical warning applies
M.A. Ford Twister Al 5X Drill No 50
This drill bit is engineered for aluminium and similar non-ferrous materials. Its three-flute geometry supports efficient chip evacuation during high-speed drilling. The tool targets machinists and fabricators who need consistent hole quality in soft metals. It is not suited for hardened steel, stainless alloys or abrasive composites.
5X diameter capacity and chip control
The 5X length-to-diameter ratio provides extended reach for deeper holes while maintaining rigidity. Three flutes balance material removal rate with evacuation space, reducing the risk of packing in ductile aluminium. In very deep holes or high-feed scenarios, chip breakage may still require peck cycles. The design does not address coolant-through requirements.
Solid carbide construction and shank fit
The solid carbide body delivers wear resistance and stiffness for repeatable sizing. A standard cylindrical shank fits common collets and drill chucks without proprietary holders. No internal coolant channels are present, so external flood or mist lubrication must be arranged. The tool carries a California Proposition 65 warning for listed chemicals.
Highlights
- Three-flute design improves chip evacuation in aluminium
- 5X diameter drilling depth capability
- No 50 drill size for precise hole diameter
- M.A. Ford manufacturing quality
- California Proposition 65 chemical warning applies
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
Will the No 50 drill fit the same chuck I use for my other twist drills?
The No 50 drill has a standard shank that fits common drill chucks used with other twist drills.
How can I verify the Twister Al 5X is cutting correctly after I start drilling?
Check for smooth chip evacuation through the three flutes and a clean hole without excessive heat buildup.
Does the 22907000 package include any lubricant or cutting fluid for aluminium?
The box contains only the drill; cutting fluid or lubricant must be purchased separately.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
