M.A. Ford
M.A. Ford Twister Al 5X 3 Flute Drill No 37 22910400
Three-flute drill bit for aluminium, size 37, five times diameter depth
- Three-flute design improves chip evacuation in aluminium
- 5× diameter reach extends drilling depth without pecking
- No 37 size targets precise hole requirements
- M.A. Ford manufacturing ensures consistent cutting geometry
- California Proposition 65 warning discloses regulated chemical content
Twister Al 5X 3 Flute Drill No 37
The M.A. Ford Twister Al 5X is a three-flute drill engineered for aluminium machining. It is built for workshops and production lines that need consistent hole quality in non-ferrous materials. The tool carries the manufacturer part number 22910400 and ships new from the supplier.
Suited for aluminium drilling, not other materials
This drill suits operators cutting aluminium alloys where the 5X geometry and three-flute design promote chip evacuation and finish. Buyers who need to drill steel, titanium or composite stacks should look at a different tool because the geometry is optimised specifically for aluminium.
5X geometry gives headroom in aluminium
The 5X design provides extended tool life and higher feed rates in suitable aluminium grades, reducing cycle time on repetitive jobs. In harder alloys or deep-hole applications the drill will reach its wear limit sooner, so users running those conditions should plan for more frequent tool changes.
Highlights
- Three-flute design improves chip evacuation in aluminium
- 5× diameter reach extends drilling depth without pecking
- No 37 size targets precise hole requirements
- M.A. Ford manufacturing ensures consistent cutting geometry
- California Proposition 65 warning discloses regulated chemical content
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
What type of chuck or tool holder is needed to run the No 37 Twister Al 5X 3 Flute Drill?
The No 37 drill has a standard shank that fits any drill chuck or collet sized for a No 37 wire-gauge bit.
Can the Twister Al 5X 3 Flute Drill No 37 be used in a corded drill that only accepts round shanks?
Yes, the No 37 shank is round and will seat securely in a keyed or keyless chuck designed for round-shank bits.
How can I confirm the 22910400 drill is cutting correctly after I start the hole?
You should see clean, continuous chips and a smooth hole wall with no chatter or excessive heat buildup.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
