M.A. Ford
M.A. Ford Twister Al 5X 3 Flute Drill No 12 part 22918900
A number 12 three-flute drill designed for aluminium with a 5x diameter reach
- Twister Al 5X design drills aluminium efficiently
- Three-flute geometry clears chips smoothly
- Number 12 size matches standard drill charts
- New condition ensures full factory performance
- California Proposition 65 warning lists chemical hazards
Purpose & Audience
The M.A. Ford Twister Al 5X 3 Flute Drill No 12 is a new cutting tool designed for drilling aluminium and other non-ferrous materials. It suits machinists and fabricators who need a dedicated geometry for softer metals. Buyers who require a drill for hardened steel or high-temperature alloys should select a different tool.
Sustained Load Behaviour
The three-flute design and 5X geometry promote stable chip evacuation during extended drilling cycles in aluminium. This reduces the tendency for built-up edge that can degrade hole quality over time. The flute form helps maintain consistent cutting forces when the tool remains engaged for longer periods.
Build & Connectors
The drill carries the manufacturer part number 22918900 for accurate identification and reordering. A California Proposition 65 notice applies, stating the product contains a chemical known to cause cancer and birth defects or other reproductive harm. Users should follow standard workshop safety practices and wear appropriate personal protective equipment.
Highlights
- Twister Al 5X design drills aluminium efficiently
- Three-flute geometry clears chips smoothly
- Number 12 size matches standard drill charts
- New condition ensures full factory performance
- California Proposition 65 warning lists chemical hazards
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
How much heat does the No 12 Twister Al 5X drill generate during continuous use?
The 3 flute design on this 5X drill helps evacuate chips efficiently, which reduces friction and heat buildup when drilling aluminium.
What tool holder or chuck is required to run the 22918900 drill bit?
The drill has a straight shank sized for a standard chuck or collet that accepts a No 12 diameter tool.
Will the No 12 Twister Al 5X drill work in an older drill press with lower spindle speeds?
The geometry is optimised for aluminium at higher speeds, but the 3 flute design still cuts cleanly at the reduced RPM of older machines.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
