M.A. Ford
M.A. Ford Twister Al 5X 3 Flute Drill No 11 22919100
A No 11 size 3-flute drill with 5x diameter flute length for aluminium alloys
- Three-flute geometry improves chip evacuation in aluminium
- 5× diameter drilling depth reaches deeper holes
- Number 11 size matches standard tap-drill charts
- M.A. Ford construction delivers reliable cutting performance
- California Proposition 65 warning included for chemical awareness
M.A. Ford Twister Al 5X Drill
This M.A. Ford drill is a No 11 size cutting tool built with a 3-flute geometry and a 5X designation for aluminium work. It is supplied new from the manufacturer and intended for machinists and fabricators producing precise holes in non-ferrous materials. The part carries the manufacturer number 22919100 for identification and reordering.
Suited for aluminium drilling; not for other needs
The 3-flute Twister Al 5X design serves shops that need efficient chip evacuation and finish quality in aluminium. Buyers who require a different flute count, a different diameter series, or a tool optimised for steel, titanium or composite materials should look at other product lines. This item does not address those applications.
California Proposition 65 notice applies
This product carries a California Proposition 65 warning for exposure to a chemical known to the state to cause cancer and a chemical known to cause birth defects or other reproductive harm. Users should review the manufacturer's safety data and follow applicable handling, ventilation and personal-protection practices when machining with this drill.
Highlights
- Three-flute geometry improves chip evacuation in aluminium
- 5× diameter drilling depth reaches deeper holes
- Number 11 size matches standard tap-drill charts
- M.A. Ford construction delivers reliable cutting performance
- California Proposition 65 warning included for chemical awareness
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
What drill chuck size is required for the No 11 shank on the Twister Al 5X drill?
A chuck that accepts a No 11 drill shank will hold the 22919100 bit securely for aluminium work.
Can the Twister Al 5X drill be used in a cordless drill that previously ran standard twist bits?
Yes, the 3-flute geometry fits any chuck that takes a No 11 shank, so older cordless drills drive it without issue.
How can I confirm the Twister Al 5X drill is cutting correctly after installing it?
Smooth, continuous chips and a quiet, steady cut in aluminium show the 3-flute design is performing as intended.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
