M.A. Ford
M.A. Ford Twister Al 5X 3 Flute Drill 9/16 22956250
Three-flute drill cuts aluminium efficiently with a 9/16-inch diameter
- Twister Al 5X geometry cuts aluminium cleanly
- Three-flute design evacuates chips faster than two-flute drills
- 9/16 inch diameter suits common hole sizes
- California Proposition 65 notice warns of listed chemicals
- Brand-new condition ensures full factory performance
M.A. Ford Twister Al 5X Drill
The M.A. Ford Twister Al 5X is a 9/16 inch three flute drill built for high performance drilling in aluminium and similar non-ferrous materials. Its specialised geometry reduces chip welding and improves evacuation during deep hole operations. The tool carries the manufacturer part number 22956250 and arrives in new condition.
Machinists working with aluminium alloys
This drill suits machinists and fabricators who need fast, clean holes in aluminium without the clogging common with standard twist drills. Workshops focused on steel, stainless steel or high temperature alloys should look at alternative tooling because the Al 5X geometry is optimised specifically for softer non-ferrous metals. Buyers who require internal coolant supply or a different shank style will also need a different product.
9/16 inch diameter three flute design
The 9/16 inch cutting diameter with three flutes is the primary specification that determines fit for the intended hole size and material removal rate. California Proposition 65 warnings apply as the product contains chemicals known to the State of California to cause cancer and birth defects or other reproductive harm. Verify the diameter matches the job requirement before ordering.
Highlights
- Twister Al 5X geometry cuts aluminium cleanly
- Three-flute design evacuates chips faster than two-flute drills
- 9/16 inch diameter suits common hole sizes
- California Proposition 65 notice warns of listed chemicals
- Brand-new condition ensures full factory performance
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
Will the 9/16 inch Twister Al 5X 3 Flute Drill fit my existing 1/2 inch drill chuck?
The 9/16 inch shank exceeds standard 1/2 inch chuck capacity so a larger chuck or a reduced-shank adapter is required for your current drill.
How can I confirm the 22956250 drill is cutting correctly in aluminium?
Expect clean, straight holes with consistent silver chips and no built-up edge on the three flutes when running at recommended aluminium speeds.
Does the 22956250 package include any drill bits or only the single Twister Al cutter?
The box contains one 9/16 inch Twister Al 5X 3 Flute Drill; no additional bits, lubricants or accessories are supplied.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
