M.A. Ford
M.A. Ford Twister Al 5X 3 Flute Drill 6.20 mm 22924410
Three-flute carbide drill cuts aluminium five times diameter deep at 6.20 mm
- 5x diameter reach for deep holes
- 3-flute design improves chip evacuation
- 20 mm diameter suits precise drilling
- M.A. Ford manufacturing ensures reliability
- New condition guarantees full performance
6.20 mm Twister Al 5X drill
The M.A. Ford Twister Al 5X is a three-flute drill bit sized at 6.20 mm for aluminium and other non-ferrous metals. It targets machinists and fabricators who need accurate holes in softer alloys. The 5X designation marks the series within the Twister Al range. Buyers working primarily in steel, titanium or hardened materials should select a different geometry.
Three-flute capacity and chip control
Three flutes give more cutting edges than a standard two-flute bit, so feed rates can be higher while chip evacuation stays manageable in ductile aluminium. The design handles typical wall-thickness holes and through-holes in plate without packing. Very deep holes or high-silicon castings may exceed the flute capacity and require peck cycles or a specialist geometry.
Prop 65 chemical notice
California Proposition 65 warnings accompany this product because it contains a substance listed as a carcinogen and a reproductive toxin. The notice is a regulatory requirement and does not describe a functional limit of the drill. Users who must avoid listed chemicals entirely will need an alternative tool. No other interface or material standard is referenced in the data.
Highlights
- 5x diameter reach for deep holes
- 3-flute design improves chip evacuation
- 20 mm diameter suits precise drilling
- M.A. Ford manufacturing ensures reliability
- New condition guarantees full performance
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
Will the 6.20 mm shank on this Twister Al drill fit the chuck on my older drill press?
The drill has a 6.20 mm diameter. Measure your chuck capacity or collet size to confirm it accepts that dimension.
How can I verify the 3 flute geometry is cutting correctly once installed?
Run a test hole in aluminium. You should see three evenly spaced chips and a smooth bore with no chatter marks.
Does the box for part 22924410 include any coolant or lubricant, or must I buy that separately?
The package contains only the drill bit. Cutting fluid or mist coolant for aluminium must be purchased separately.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
