M.A. Ford
M.A. Ford Twister Al 5X 3 Flute Drill 4.10mm 22916140
A three-flute 4.10 mm drill designed for aluminium with five-times diameter reach
- Designed for aluminium with three-flute geometry
- 5× diameter reach for deeper holes
- 10 mm cutting diameter for precise bores
- M.A. Ford manufacturing for consistent tool life
- New condition ensures full factory performance
M.A. Ford Twister Al 5X Drill
The M.A. Ford Twister Al 5X 3 Flute Drill is a precision cutting tool manufactured by M.A. FORD for drilling aluminium and similar non-ferrous materials. It carries the manufacturer part number 22916140 and is supplied in new condition. This drill is intended for machinists and fabricators who require a dedicated geometry for aluminium work.
Suited for aluminium drilling, not steel
The three-flute design and specialised geometry suit workshops producing holes in aluminium alloys where chip evacuation and finish quality are priorities. Buyers who need a drill for steel, stainless steel or hardened alloys should look at a different tool because this model is optimised for non-ferrous applications only. The product carries California Proposition 65 warnings for chemicals known to cause cancer and birth defects or other reproductive harm.
4.10 mm cutting diameter
The decisive specification is the 4.10 mm cutting diameter, which determines the hole size this drill produces and must match the required specification for the job. Verify that this exact diameter fits the intended application before purchase. Orders of $75 or more ship free directly from the manufacturer.
Highlights
- Designed for aluminium with three-flute geometry
- 5× diameter reach for deeper holes
- 10 mm cutting diameter for precise bores
- M.A. Ford manufacturing for consistent tool life
- New condition ensures full factory performance
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
What chuck size fits the 4.10 mm shank on the 22916140 drill bit?
Use a chuck that grips at least 4.10 mm; a standard 6 mm or 1/4 inch keyless chuck will hold it securely.
How do you install the Twister Al 5X bit without snapping the 3 flute cutting edges?
Insert the bit fully into the chuck, tighten evenly, start the drill at low RPM, and apply steady pressure — do not force the flutes into the workpiece.
When should the 22916140 drill bit be replaced based on wear?
Replace the bit when the 3 flute cutting lips show visible rounding, chip evacuation slows, or hole diameter exceeds 4.10 mm tolerance.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
