M.A. Ford
M.A. Ford Twister Al 5X 3 Flute Drill 29/64
A 29/64 inch three-flute drill designed for aluminium and similar materials
- Twister Al 5X design optimised for aluminium drilling
- 3-flute geometry improves chip evacuation and hole quality
- 29/64 inch diameter suits precise fractional sizing
- New condition guarantees full factory performance
- Prop 65 notice confirms regulated substance disclosure
M.A. Ford Twister Al 5X Drill
The M.A. Ford Twister Al 5X is a three-flute drill bit sized at 29/64 inch. It is built for machinists and fabricators who need accurate holes in aluminium and similar non-ferrous materials. The specialised geometry reduces chatter and improves chip evacuation during high-speed runs. This tool suits production environments where repeatable hole quality matters.
Installation and common issues
The drill fits standard 29/64 inch tool holders and collets without adapters. Secure the workpiece firmly to prevent vibration that can damage the cutting edges. Excessive feed rates or insufficient coolant often cause premature wear or breakage. Always match spindle speed to the material specification to avoid overheating the flutes.
29/64 inch three-flute geometry
The 29/64 inch diameter and three-flute design determine whether this bit matches the required hole size and chip-load capacity. Verify the exact diameter against your drawing before ordering. The flute count influences feed rate and finish quality in aluminium alloys. California Proposition 65 warnings apply to this product.
Highlights
- Twister Al 5X design optimised for aluminium drilling
- 3-flute geometry improves chip evacuation and hole quality
- 29/64 inch diameter suits precise fractional sizing
- New condition guarantees full factory performance
- Prop 65 notice confirms regulated substance disclosure
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
How can I verify the 29/64 Twister Al 5X drill is cutting correctly after chucking it up?
Run the drill in aluminium and check for smooth chip evacuation through the three flutes without excessive heat or chatter.
What comes with the 22945310 Twister Al 5X 3 Flute Drill and what must I supply?
The box contains the 29/64 drill bit only; you must provide a compatible drill chuck, cutting fluid and workpiece clamping.
Which diameter should I choose from the Twister Al 5X range for a 29/64 hole?
Select the 29/64 variant — it is the exact size listed for this 22945310 model.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
