M.A. Ford
M.A. Ford Twister Al 5X 3 Flute Drill 13.50Mm 22953150
A 13.50 mm three-flute drill designed for aluminium with a 5x diameter reach
- Designed for aluminium with three-flute geometry
- 50 mm diameter suits precise hole sizing
- Five-times diameter reach for deeper drilling
- M.A. Ford manufacturing ensures consistent quality
- California Prop 65 chemical warning applies
Twister Al 5X 3 Flute Drill 13.50mm
The M.A. Ford Twister Al 5X is a 13.50 mm three-flute drill designed for aluminium and similar non-ferrous materials. It suits CNC operators and workshop machinists who need accurate holes in soft alloys. The 5X designation indicates a high-performance geometry optimised for faster material removal in these specific metals.
Upgrade from standard high-speed steel drills
Conventional HSS drills tend to clog and wander in aluminium, leading to oversize holes and poor finish. The Twister Al 5X replaces those tools when cycle time and hole quality become critical. The jump is worth it for production runs where consistent diameter and reduced rework outweigh the higher unit cost of the specialised cutter.
Installation and common issues
The drill fits any holder that accepts a 13.50 mm shank, so no adapter is required for standard collets or chucks. Most problems arise from incorrect speed and feed settings, which cause built-up edge or chatter. Rigid workpiece clamping and flood coolant prevent deflection and chip packing, the two failure modes seen most often in soft-metal drilling.
Highlights
- Designed for aluminium with three-flute geometry
- 50 mm diameter suits precise hole sizing
- Five-times diameter reach for deeper drilling
- M.A. Ford manufacturing ensures consistent quality
- California Prop 65 chemical warning applies
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
What size drill chuck is required for the 13.50 mm shank?
Use a drill chuck that accepts a 13.50 mm diameter shank; the Twister Al 5X 3 Flute Drill has a straight round shank of that size.
How do you install the drill bit without damaging the flutes?
Insert the shank fully into the chuck, tighten evenly on all three jaws, and avoid side pressure while the bit seats.
When should the drill bit be replaced?
Replace the bit when the three cutting edges show visible wear, chipping, or when hole quality in aluminium deteriorates.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
