M.A. Ford
M.A. Ford Twister Al 5X 3 Flute Drill 11.50mm 22945280
Three-flute 11.50 mm drill designed for aluminium with five-times diameter reach
- Three-flute design evacuates chips efficiently in aluminium
- 5× diameter reach drills deeper holes without pecking
- 50 mm diameter matches precise hole specifications
- M.A. Ford manufacturing delivers consistent cutting performance
- California Proposition 65 warning informs safe handling practices
11.50 mm 3-flute drill for aluminium
The M.A. Ford Twister Al 5X drill has a 11.50 mm diameter and three flutes designed for aluminium work. It is manufactured under part number 22945280 and supplied new. The tool carries a California Proposition 65 notice for cancer and reproductive-harm chemicals.
Machinists needing a dedicated aluminium bit
This drill suits CNC operators and metalworkers who need a 11.50 mm hole in aluminium alloys. It is not intended for buyers who require a different diameter, a higher flute count or a coating not described in the data.
11.50 mm cutting diameter decides fit
The single specification that determines whether this is the correct part is the 11.50 mm cutting diameter. Verify that your application calls for exactly this size before ordering.
Highlights
- Three-flute design evacuates chips efficiently in aluminium
- 5× diameter reach drills deeper holes without pecking
- 50 mm diameter matches precise hole specifications
- M.A. Ford manufacturing delivers consistent cutting performance
- California Proposition 65 warning informs safe handling practices
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
What drill chuck size is required to hold the 11.50mm shank of the Twister Al 5X drill?
A chuck capacity of at least 11.50mm is needed to secure the drill shank during operation.
Will the Twister Al 5X drill perform correctly when driven by a standard cordless drill motor?
Yes, the 3-flute geometry is designed for stable cutting on portable drill motors at appropriate speeds.
How can I verify the Twister Al 5X drill is cutting properly after installation?
Check for consistent chip formation and a smooth hole surface without chatter marks at the 11.50mm diameter.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
