M.A. Ford
M.A. Ford Tuffcut GP 15019680C 2 Flute Ball Nose End Mill 5.0mm
A 5.0 mm two-flute ball-nose end mill for contoured milling in a variety of materials
- Two-flute design clears chips efficiently in slotting operations
- 0 mm ball nose radius produces smooth 3D contours
- M.A. Ford TuffCut GP geometry handles general-purpose milling tasks
- California Proposition 65 warning discloses regulated chemical content
- Manufacturer direct shipping available for qualifying orders
M.A. Ford Tuffcut GP 5.0mm End Mill
The M.A. Ford Tuffcut GP 15019680C is a 2 flute ball nose end mill with a 5.0mm cutting diameter. It is designed for general-purpose milling in a range of materials using CNC machines or manual milling equipment. The tool suits machinists and fabricators who need a reliable cutter for profiling, slotting and contouring operations.
Installation in standard tool holders
The 5.0mm shank fits directly into ER collets, Weldon flats or shrink-fit holders sized for that diameter. Secure clamping prevents run-out and vibration during cutting. Problems usually arise when the holder is worn, undersized or contaminated, which can cause the tool to slip or break under load.
Limits of the 2 flute ball nose geometry
Two flutes provide large chip space but limit feed rates compared to higher flute counts in harder alloys. The ball nose profile excels at 3D contouring yet leaves a scalloped finish on flat floors that may need a secondary pass. California Proposition 65 warnings apply because the tool contains substances identified by the state as carcinogenic and reproductive toxins.
Highlights
- Two-flute design clears chips efficiently in slotting operations
- 0 mm ball nose radius produces smooth 3D contours
- M.A. Ford TuffCut GP geometry handles general-purpose milling tasks
- California Proposition 65 warning discloses regulated chemical content
- Manufacturer direct shipping available for qualifying orders
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
How do I know the 5.0 mm ball nose is cutting correctly after setup?
A proper cut shows a smooth radius finish without chatter marks; the two flutes should evacuate chips cleanly and leave a consistent surface on the workpiece.
What comes in the box and what must I source separately?
The box contains the 5.0 mm Tuffcut GP end mill only; a compatible tool holder, collet or shrink-fit adapter for your machine spindle must be purchased separately.
Which version of the 15019680C should I choose for general-purpose milling?
The listed 15019680C is a single 5.0 mm, 2-flute ball-nose configuration; select it when you need that exact diameter and flute count for profiling or contour work.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
