M.A. Ford
M.A. Ford TuffCut DM 156M0160N16A 1.6 mm ball nose end mill
A 1.6 mm ball nose end mill with a necked 2-flute design for contoured milling
- TypeCutting Tools
- 2-flute ball nose design enables smooth contour milling
- 6 mm cutting diameter suits fine-detail machining
- Necked profile provides extended reach in deep cavities
- TuffCut DM series built for hardened-material performance
- New condition ensures full tool life from first use
1.6 mm ball nose end mill
The M.A. Ford TuffCut DM 156M0160N16A is a 1.6 mm diameter ball nose end mill with a necked shank and two flutes. It is supplied new and intended for precision milling operations in a workshop or light industrial setting.
Sustained cutting performance
The two-flute geometry and necked design promote chip evacuation during extended passes, helping to maintain consistent material removal without excessive heat buildup. The tool is built for repetitive profiling and contouring rather than heavy roughing cycles.
1.6 mm cutting diameter
This specific diameter determines whether the mill suits the required radius or finishing pass; it cannot be substituted for larger or smaller features. Buyers needing a different radius or a higher flute count for finer surface finish should select another tool.
Highlights
- 2-flute ball nose design enables smooth contour milling
- 6 mm cutting diameter suits fine-detail machining
- Necked profile provides extended reach in deep cavities
- TuffCut DM series built for hardened-material performance
- New condition ensures full tool life from first use
Specifications
| Brand | M.A. FORD |
|---|---|
| Type | Cutting Tools |
Questions about this item
Does the 1.6 mm ball nose generate noticeable vibration or heat during extended CNC sessions?
The 2 flute necked design reduces chatter and heat buildup, but cutting parameters and coolant choice determine actual temperature and noise levels.
What shank diameter must my collet or holder accept for the 156M0160N16A to seat correctly?
The shank matches the 16 mm neck specification, so a 16 mm collet or shrink-fit holder is required.
Can this 1.6 mm end mill run on an older CNC router limited to 16 000 rpm without tool deflection?
At 1.6 mm diameter the tool is rigid enough for moderate speeds, but feed rates must be lowered to avoid deflection on machines capped at 16 000 rpm.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
