M.A. Ford
M.A. Ford Tuffcut Al 2 Flute End Mill Necked 5/16
Two-flute necked end mill cuts aluminium with extended reach for deep pockets
- TypeCutting Tools
- Designed for aluminium machining with a two-flute cutting geometry
- Necked profile provides extended reach in deep pockets and cavities
- 5/16 inch cutter diameter suits a wide range of milling tasks
- M.A. Ford quality ensures consistent performance in production environments
- California Proposition 65 warning notes chemical exposure risks
M.A. Ford Tuffcut Al 2 Flute End Mill
The M.A. Ford Tuffcut Al 2 Flute End Mill Necked is a cutting tool designed for aluminium machining. Its two-flute geometry and necked profile support chip evacuation in deeper slots and pockets. The tool is supplied new and ships directly from the manufacturer.
Aluminium machining specialists
Shops that regularly cut aluminium alloys will benefit from the flute design optimised for that material. Operations focused on steel, titanium or hardened metals should select a tool with a different substrate and geometry. Buyers needing a higher flute count for finishing passes or a different shank style should look at other ranges.
California Proposition 65 notice
This product contains a chemical known to the State of California to cause cancer and birth defects or other reproductive harm. The warning applies to the item as supplied. Users should follow standard workshop safety practices and consult the safety data sheet for handling guidance.
Highlights
- Designed for aluminium machining with a two-flute cutting geometry
- Necked profile provides extended reach in deep pockets and cavities
- 5/16 inch cutter diameter suits a wide range of milling tasks
- M.A. Ford quality ensures consistent performance in production environments
- California Proposition 65 warning notes chemical exposure risks
Specifications
| Brand | M.A. FORD |
|---|---|
| Type | Cutting Tools |
Questions about this item
How much heat does the 135B31251N end mill generate during continuous aluminium cutting?
The tool itself does not produce heat; heat comes from the cutting action and depends on spindle speed, feed rate and coolant use.
What shank size and holder does the 5/16 necked cutter require?
It needs a 5/16 inch shank-compatible collet or end-mill holder and a rigid milling machine spindle.
Will the 135B31251N fit an older Bridgeport-style mill with R8 taper?
Yes, if you use an R8-to-5/16 collet or adapter, the cutter will work on that machine.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
