M.A. Ford
M.A. Ford Tuffcut Al 2 Flute End Mill Necked 12.0mm
A 12.0mm necked two-flute end mill designed for aluminium cutting applications
- TypeCutting Tools
- Precision milling with 2-flute aluminium design
- Neck geometry allows deeper cavity access
- 0 mm diameter suits standard tooling
- California Proposition 65 chemical warning applies
- Brand-new condition from M.A. Ford
Tuffcut Al 2 Flute End Mill 12.0mm
This M.A. Ford cutting tool is a two-flute end mill with a necked design and a 12.0mm diameter. It is intended for machining operations that require aluminium-specific geometry. The product ships new directly from the manufacturer.
Upgrading from standard end mills
A necked profile provides additional reach for deep pockets or cavities where a standard flute length cannot clear. The two-flute design prioritises chip evacuation in non-ferrous materials. Buyers who need higher flute counts for finishing passes or different substrate coatings should evaluate other tooling options.
California Proposition 65 compliance
This item carries a Proposition 65 warning for chemicals known to the State of California to cause cancer and reproductive harm. Safe handling practices and appropriate personal protective equipment are required during use. Orders of $75 or more qualify for free shipping from the supplier.
Highlights
- Precision milling with 2-flute aluminium design
- Neck geometry allows deeper cavity access
- 0 mm diameter suits standard tooling
- California Proposition 65 chemical warning applies
- Brand-new condition from M.A. Ford
Specifications
| Brand | M.A. FORD |
|---|---|
| Type | Cutting Tools |
Questions about this item
What collet or holder size fits the 12.0 mm shank of this end mill?
Use a 12.0 mm ER collet, shrink-fit holder or hydraulic chuck with a matching bore; the necked section requires clearance behind the collet face.
Which step do operators most often miss when setting up this necked cutter?
They forget to measure tool length after the neck, so the programmed Z-zero sits at the shank instead of the cutting edges.
When should this Tuffcut Al cutter be replaced in aluminium work?
Replace it once flank wear lands reach the wear-mark line or when built-up edge starts leaving a cloudy finish on the workpiece.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
