M.A. Ford
M.A. Ford HPDCR 1590A Twister HPD Coolant Drill 5X 15.90 mm
A 15.90 mm coolant-fed drill bit designed for high-performance drilling applications
- Coolant-fed design evacuates heat for longer tool life
- 5× diameter reach drills deeper holes in a single pass
- 90 mm diameter suits precise machining tasks
- Twister HPD geometry improves chip evacuation and hole quality
- California Proposition 65 warning informs safe handling practices
M.A. Ford HPDCR 1590A Twister Drill
The M.A. Ford HPDCR 1590A Twister is a high-performance coolant drill designed for precision holemaking. It features a 15.90 mm diameter and a 5X diameter drilling depth capability. This new power tool targets professional machinists and fabrication shops requiring accurate deep-hole drilling in metal components.
Suited for deep-hole metal drilling tasks
This drill suits operators producing holes up to five times the tool diameter in steel or alloy workpieces. The through-coolant design supports chip evacuation and temperature control during extended cycles. Buyers needing larger diameters, non-coolant tooling, or indexable insert systems should evaluate alternative product lines instead.
Sustained load performance with coolant feed
Under continuous operation the internal coolant channel delivers cutting fluid directly to the drill point, stabilising tip temperature and reducing thermal wear. Consistent fluid pressure maintains chip breaking and evacuation at full 5X depth, preventing packing that can stall the spindle. The carbide construction retains hardness throughout the cut, preserving hole size and surface finish over long production runs.
Highlights
- Coolant-fed design evacuates heat for longer tool life
- 5× diameter reach drills deeper holes in a single pass
- 90 mm diameter suits precise machining tasks
- Twister HPD geometry improves chip evacuation and hole quality
- California Proposition 65 warning informs safe handling practices
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
What size drill chuck do I need for the 15.90 mm shank on this Twister HPD drill?
The drill has a 15.90 mm diameter shank, so you need a chuck that opens to at least 15.90 mm or a sleeve that matches that exact size.
Can I run this coolant-fed drill on a standard machine without through-spindle coolant?
This model is designed for through-coolant delivery; without a machine that supplies coolant through the spindle you cannot use its internal cooling channels as intended.
How do I confirm coolant is reaching the cutting edges after I install the drill?
Start the machine at low speed with coolant on and watch for a steady stream exiting the two flute outlets at the drill point before you begin cutting.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
