M.A. Ford
M.A. Ford HPDCR 1250A Twister HPD Coolant Drill 5X 12.50mm
A 12.50 mm coolant-fed drill designed for high-performance drilling applications
- Precision drilling with 5X coolant-through design
- 50 mm diameter for accurate hole sizing
- M.A. Ford engineering for reliable performance
- New condition ensures full tool life
- California Proposition 65 compliance for safety awareness
M.A. Ford HPDCR 1250A Twister Drill
The M.A. Ford HPDCR 1250A Twister is a high-performance coolant drill built for demanding metalworking tasks. It features a 12.50 mm diameter and a 5X diameter drilling depth capability. This new tool targets professional machinists and fabricators who require precise, deep-hole drilling in tough materials. Its design supports efficient chip evacuation during operation.
Suited for deep-hole metal drilling
This drill suits workshops producing deep holes in steel, stainless steel, or high-temperature alloys where coolant-through capability is essential. It is not for hand-held use or soft materials like wood and plastic. Buyers needing larger diameters or non-coolant drills should look at other tooling. The specialised geometry limits versatility for general-purpose bench work.
12.50 mm diameter with 5X depth
The defining specification is the 12.50 mm cutting diameter combined with a 5X diameter drilling depth. This ratio determines the maximum reach achievable in a single pass without pecking. Match this size exactly to your hole requirements and machine capacity. The tool is manufactured by M.A. Ford and carries a California Proposition 65 warning.
Highlights
- Precision drilling with 5X coolant-through design
- 50 mm diameter for accurate hole sizing
- M.A. Ford engineering for reliable performance
- New condition ensures full tool life
- California Proposition 65 compliance for safety awareness
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
What machine spindle is required to run the 12.50 mm Twister HPD coolant drill?
A machine spindle that accepts a 12.50 mm shank and can deliver through-spindle coolant at the pressure recommended for 5×D drilling.
Can the 12.50 mm Twister HPD drill be used in a holder that only offers external flood coolant?
The drill is designed for through-tool coolant; external flood alone may not clear chips reliably at 5×D depth.
How do I confirm the 12.50 mm Twister HPD drill is cutting correctly after installation?
Check for consistent chip formation, steady spindle load, hole diameter within tolerance and no excessive flank wear after the first few holes.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
