M.A. Ford
M.A. Ford HPDCR 0650A Twister HPD Coolant Drill 5X 6.50 mm
A 6.50 mm coolant-fed drill with 5×D drilling depth for high-performance holemaking
- Twister HPD design optimises coolant delivery for efficient drilling
- 50 mm diameter suits precise hole-making tasks
- 5X coolant capability supports extended high-performance drilling
- M.A. Ford engineering ensures reliable power tool operation
- California Proposition 65 warning informs safe handling awareness
6.50 mm Coolant Drill for High-Performance Drilling
The M.A. Ford HPDCR 0650A Twister HPD is a coolant-fed drill built for 5X diameter depth in a single pass. It targets machine shops and production cells that need accurate deep holes without peck cycles. The 6.50 mm diameter suits standard metric tap sizes and fixture work.
Through-Coolant Design Manages Heat
Internal coolant channels deliver fluid to the cutting zone, reducing thermal load on the tool and workpiece. This steady flow flushes chips from deep flutes, lowering cutting forces and acoustic output during continuous cuts. Consistent cooling supports stable power draw on the spindle.
Replaces Conventional Twist Drills When Depth
Shops moving from external-coolant or solid drills gain cycle-time savings on holes deeper than three diameters. The step is justified when pecking slows throughput or when chip packing damages parts. It does not suit shallow-hole work where a standard drill is faster to change.
Highlights
- Twister HPD design optimises coolant delivery for efficient drilling
- 50 mm diameter suits precise hole-making tasks
- 5X coolant capability supports extended high-performance drilling
- M.A. Ford engineering ensures reliable power tool operation
- California Proposition 65 warning informs safe handling awareness
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
How do I install the 6.50 mm Twister HPD coolant drill in a CNC spindle?
Clamp the shank in a precision collet or hydraulic holder rated for the 6.50 mm diameter, run the spindle at the recommended speed for the workpiece material, and activate through-spindle coolant before the drill contacts the part.
What maintenance will the 6.50 mm Twister HPD drill need after extended use?
Inspect the cutting lips and margin lands for wear or chipping after each shift, clean coolant passages with compressed air, and send the tool to a qualified regrinding service when flank wear reduces cutting performance.
What limit appears first when the 6.50 mm drill runs continuously in deep holes?
Chip evacuation becomes the limiting factor once hole depth exceeds five times the 6.50 mm diameter, so monitor coolant pressure and consider peck cycles to prevent packing.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
