M.A. Ford
M.A. Ford HPDCR 0580A Twister HPD Coolant Drill 5X 5.80 mm
A 5.80 mm coolant-fed drill with 5× diameter depth capability for high-performance drilling
- Twister HPD design enables efficient coolant-through drilling
- 5X diameter reach extends hole depth in a single pass
- 80 mm diameter suits precise metric hole requirements
- M.A. Ford manufacturing delivers professional-grade tool reliability
- California Proposition 65 warning indicates regulated chemical content
Twister HPD Coolant Drill 5X 5.80 mm
The M.A. Ford Twister HPDCR 0580A is a high-performance coolant drill designed for precision holemaking in demanding materials. It serves machinists and fabricators who require a 5X diameter drilling depth with internal coolant delivery. This tool targets professional workshops needing reliable penetration in tough alloys.
5.80 mm diameter with 5X depth capability
The 5.80 mm cutting diameter provides a specific hole size for downstream operations such as tapping or reaming. The 5X length-to-diameter ratio allows deeper holes in a single pass, reducing cycle time and improving concentricity. Internal coolant channels evacuate chips efficiently, though the tool reaches its limit in extremely deep or interrupted cuts where rigidity becomes critical.
California Proposition 65 chemical warning applies
This product contains a chemical known to the State of California to cause cancer and birth defects or other reproductive harm. Users must review safety data sheets and implement appropriate handling controls such as ventilation and personal protective equipment. Compliance with Proposition 65 is a regulatory requirement for distribution and use within California.
Highlights
- Twister HPD design enables efficient coolant-through drilling
- 5X diameter reach extends hole depth in a single pass
- 80 mm diameter suits precise metric hole requirements
- M.A. Ford manufacturing delivers professional-grade tool reliability
- California Proposition 65 warning indicates regulated chemical content
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
Will the 5.80 mm drill fit my existing 6 mm drill chuck?
Yes, a 5.80 mm shank fits a standard 6 mm chuck; the jaws close fully around the smaller diameter.
How can I confirm coolant is flowing through the Twister HPD drill during use?
Watch for a steady stream of coolant exiting the hole flutes while the spindle runs; interrupted flow means a blockage.
Does the box include coolant fluid or only the drill bit?
Only the 5.80 mm Twister HPD drill bit is supplied; coolant fluid must be purchased separately.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
