M.A. Ford
M.A. Ford Cyclone Xd 8X Coolant Fed Double Margin Drill 6.90 mm
Coolant-fed double-margin drill with 6.90 mm diameter for deep-hole precision
- Coolant-fed design improves chip evacuation during deep drilling
- Double-margin geometry enhances hole accuracy and surface finish
- 8× diameter capability reaches deeper holes in one pass
- 90 mm diameter suits precise metric applications
- New condition ensures full factory performance from first use
Cyclone Xd 8X Coolant-Fed Drill
The M.A. Ford Cyclone Xd is an 8× diameter coolant-fed double-margin drill built for high-precision holemaking. Its through-tool coolant delivery and reinforced margins suit CNC operators and job shops that need consistent accuracy in deep drilling applications.
Sustained-load behaviour
Continuous coolant flow through the flutes evacuates chips and controls heat during extended cuts, preventing built-up edge and margin wear. The double-margin design maintains hole straightness and surface finish even when the tool runs at full engagement for long periods.
Pre-order checks
Verify that your machine spindle and tool holder can deliver the required coolant pressure and flow for a 6.90 mm diameter tool. Confirm the workholding rigidity and clearance needed for an 8× length-to-diameter ratio. Review the California Proposition 65 notices regarding chemical exposure before use.
Highlights
- Coolant-fed design improves chip evacuation during deep drilling
- Double-margin geometry enhances hole accuracy and surface finish
- 8× diameter capability reaches deeper holes in one pass
- 90 mm diameter suits precise metric applications
- New condition ensures full factory performance from first use
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
How much heat does the 6.90 mm Cyclone Xd drill generate during extended use?
The drill is designed with coolant-fed channels that carry heat away from the cutting zone, keeping the tool body cooler during continuous operation.
What coolant system does the double-margin drill need to operate?
It requires a machine spindle or holder that can deliver coolant through the tool at sufficient pressure for the 8X diameter depth.
Will the 6.90 mm shank fit my existing tool holders?
The shank diameter matches the 6.90 mm cutting diameter, so it fits standard holders sized for that dimension.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
