M.A. Ford
M.A. Ford Cyclone Xd 8X Coolant Fed Double Margin Drill 6.30mm
Coolant-fed double margin drill with 8x diameter depth capacity for 6.30 mm holes
- Coolant-fed design clears chips during deep drilling
- Double-margin geometry keeps 6.30 mm holes straight
- 8× diameter reach handles long holes in one pass
- Cyclone Xd coating resists wear on tough alloys
- Prop 65 notice informs safe handling practices
6.30 mm Cyclone Xd Drill
The M.A. Ford Cyclone Xd is a coolant-fed double-margin drill with an 8X diameter-to-length ratio, designed for deep-hole drilling in production environments. It targets machinists who need accurate straightness and consistent chip evacuation in a single operation.
Coolant-fed installation notes
The through-tool coolant channel requires a compatible holder and a sealed coolant supply to function correctly; mismatched holders or insufficient pressure will cause chip packing and premature wear. Double margins reduce walk but demand precise spindle run-out and rigid workholding to avoid deflection.
Suited for deep-hole production runs
This tool suits shops running dedicated deep-hole cycles in steel or cast iron where 8X depth capability and coolant delivery are essential. Buyers who need shorter lengths, non-coolant drills, or diameters other than 6.30 mm should look at alternative series.
Highlights
- Coolant-fed design clears chips during deep drilling
- Double-margin geometry keeps 6.30 mm holes straight
- 8× diameter reach handles long holes in one pass
- Cyclone Xd coating resists wear on tough alloys
- Prop 65 notice informs safe handling practices
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
How do I confirm the 6.30 mm drill is cutting correctly after installation?
Check for consistent chip evacuation through the coolant-fed channels and verify hole diameter stays within tolerance at the 8X diameter depth.
What comes with the CXDCLM0630AP drill and what must I supply?
The drill body is included; you must provide compatible coolant-fed tool holders and cutting fluid for the double-margin design.
Which Cyclone Xd variant should I choose for a 6.30 mm hole?
Select the CXDCLM0630AP model, which is built specifically for 6.30 mm diameter drilling at 8X depth with coolant feed.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
