M.A. Ford
M.A. Ford Cyclone Xd 8X Coolant Fed Double Margin Drill 5.90mm
Coolant-fed double-margin drill with 8× diameter reach for deep-hole precision in 5.90 mm size
- 8x diameter reach drills deep holes in one pass
- Coolant-fed design clears chips and controls heat at the tip
- Double-margin construction keeps the drill centred for straighter holes
- 90 mm diameter suits precise metric hole requirements
- M.A. Ford manufacturing delivers consistent performance in demanding materials
M.A. Ford Cyclone Xd 5.90mm Drill
The M.A. Ford Cyclone Xd is a coolant-fed double-margin drill built for deep-hole drilling in tough materials. Its 8x diameter capability suits production shops and maintenance teams that need straight, accurate holes without pecking cycles. The 5.90mm cutting diameter matches metric tap-drill charts for standard thread sizes. This new tool arrives ready for high-pressure coolant systems.
Installation and common issues
Secure the drill in a precision collet or hydraulic holder to maintain runout below five microns. Verify that the machine spindle delivers the required coolant pressure through the internal channels before starting the cycle. Insufficient coolant flow or misaligned holders are the main causes of premature margin wear and hole wander. Always confirm the workpiece clamping rigidity to prevent vibration.
5.90mm diameter decides fit
The single specification that determines suitability is the 5.90mm cutting diameter. It must match the exact hole size called out in the part drawing or tap-drill chart for the intended thread. If the design requires a different diameter, this drill cannot be used. No other dimension or feature overrides this requirement.
Highlights
- 8x diameter reach drills deep holes in one pass
- Coolant-fed design clears chips and controls heat at the tip
- Double-margin construction keeps the drill centred for straighter holes
- 90 mm diameter suits precise metric hole requirements
- M.A. Ford manufacturing delivers consistent performance in demanding materials
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
How can I confirm the 5.90 mm drill is cutting correctly after setup?
Check that the coolant-fed channels deliver steady flow and that the double-margin lands produce a straight, round hole at the expected diameter.
What comes in the box and what must I supply separately?
The package contains the CXDCLM0590AP drill only; you will need to provide a compatible coolant-fed tool holder and cutting fluid.
Which version of the Cyclone Xd 8X should I choose for a 5.90 mm hole?
Select the CXDCLM0590AP model — it is the 5.90 mm diameter variant in the 8× coolant-fed double-margin series.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
