M.A. Ford
M.A. Ford Cyclone Xd 8X Coolant Fed Double Margin Drill 5.00 mm
Coolant-fed double-margin drill with 8× diameter depth capacity for 5.00 mm holes
- Coolant-fed design extends tool life by reducing heat buildup
- Double margin geometry improves hole straightness and surface finish
- 8x diameter drilling depth reaches deeper holes in one pass
- 00 mm diameter suits precise metalworking applications
- California Proposition 65 warning informs safe handling procedures
Cyclone Xd 8X Double Margin Drill
This carbide drill targets CNC machinists who need through-coolant delivery and double-margin guidance for straight, accurate holes in tough alloys. It is built for production runs where consistent chip evacuation and hole quality matter more than occasional hand-held use.
5.00 mm diameter with 8x depth capability
The 5.00 mm cutting diameter handles medium-size holes in steel, stainless and high-temp alloys up to eight diameters deep. Coolant-fed flutes push chips clear on long passes, but the fixed diameter means a separate tool is required for every other hole size.
Double-margin lands and coolant-through shank
Two supporting margins keep the drill centred, reducing walk and improving roundness on deep cuts. The through-shank coolant port demands a compatible holder and filtration; without proper pressure and clean fluid the internal passages can clog and performance drops.
Highlights
- Coolant-fed design extends tool life by reducing heat buildup
- Double margin geometry improves hole straightness and surface finish
- 8x diameter drilling depth reaches deeper holes in one pass
- 00 mm diameter suits precise metalworking applications
- California Proposition 65 warning informs safe handling procedures
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
Will the 5.00 mm Cyclone Xd 8X drill fit the collets I already use for smaller bits?
The 5.00 mm diameter matches standard 5 mm collets and chucks, so existing tool holders that accept 5 mm shanks will work without adapters.
How can I verify the coolant-fed double-margin design is functioning after installation?
Run the drill at operating pressure and confirm a steady coolant stream exits both margin channels at the cutting zone; consistent flow and even flank wear show the internal passages are clear.
Does the CXDCLM0500AP package include coolant fittings or only the drill body?
The box contains the 5.00 mm Cyclone Xd 8X drill body only; coolant supply fittings, tubing and seals must be sourced separately to complete the through-tool delivery system.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
