M.A. Ford
M.A. Ford Cyclone Xd 8X Coolant Fed Double Margin Drill 3.00mm
A 3.00 mm coolant-fed double-margin drill designed for 8× diameter depth drilling
- Coolant-fed design improves chip evacuation for deeper holes
- Double-margin geometry enhances hole straightness and finish
- 00 mm diameter suits precise drilling applications
- 8× diameter capability extends reach in tough materials
- Cyclone Xd series built for high-performance drilling
Cyclone Xd 8X Coolant Fed Drill
The M.A. Ford Cyclone Xd is a coolant fed double margin drill built for precision hole making. Its 3.00 mm diameter suits applications that require accurate small bores. The tool is supplied new and ships directly from the manufacturer.
Coolant fed operation constraints
Coolant fed designs need a machine spindle and holder that can deliver fluid through the tool. Without through coolant capability the drill cannot evacuate chips or control heat at its intended depth. Shops without that infrastructure cannot use this drill as designed.
3.00 mm diameter decides fit
The single specification that determines suitability is the 3.00 mm cutting diameter. If the hole size or pilot requirement differs from this value the drill will not produce the required feature. Verify the exact diameter before ordering.
Highlights
- Coolant-fed design improves chip evacuation for deeper holes
- Double-margin geometry enhances hole straightness and finish
- 00 mm diameter suits precise drilling applications
- 8× diameter capability extends reach in tough materials
- Cyclone Xd series built for high-performance drilling
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
What does the 8X coolant-fed double margin design mean for drilling performance?
The 8X coolant-fed double margin design delivers coolant directly to the cutting zone while the double margins guide the drill for straighter holes and improved surface finish in deep-hole applications.
How does the 3.00 mm diameter perform in a real machine setup?
At 3.00 mm the drill produces precise small-diameter holes with consistent chip evacuation when run at recommended speeds and feeds for the workpiece material.
Which shank interface does this drill use and what does it limit?
The drill uses a standard cylindrical shank that fits common drill chucks and collets, limiting use to holders that accept round shanks of this diameter.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
