M.A. Ford
M.A. Ford Cyclone XD 8X Coolant Fed Double Margin Drill 15.50mm
Coolant-fed double-margin drill cuts precise 15.50 mm holes with 8× diameter reach
- 50 mm diameter enables precise hole sizing
- 8× diameter drilling depth reaches deep features
- coolant-fed design delivers fluid to the cutting zone
- double-margin geometry improves hole straightness
- Cyclone XD series built for high-performance drilling
Cyclone XD 8X coolant-fed drill
The M.A. Ford Cyclone XD 8X is a coolant-fed double margin drill with a 15.50 mm cutting diameter. It is designed for high-performance drilling operations where consistent coolant delivery to the cutting zone is required. The double margin design supports improved hole straightness and surface finish. This tool suits professional machining environments.
Machinists needing deep-hole stability
This drill suits machinists who need reliable coolant-through capability for deep or difficult-to-machine materials. The double margin geometry helps maintain alignment in extended drilling cycles. It is not for operators without through-spindle coolant systems or those drilling shallow holes where external coolant is sufficient. Buyers needing smaller or larger diameters must select a different size.
15.50 mm diameter capacity
The 15.50 mm diameter handles production drilling in steel, cast iron and similar alloys where coolant-fed tooling extends tool life. It runs out when the machine lacks through-spindle coolant pressure or when the application demands a different diameter. The tool carries a California Proposition 65 warning for chemicals known to cause cancer and reproductive harm.
Highlights
- 50 mm diameter enables precise hole sizing
- 8× diameter drilling depth reaches deep features
- coolant-fed design delivers fluid to the cutting zone
- double-margin geometry improves hole straightness
- Cyclone XD series built for high-performance drilling
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
Does the 15.50 mm Cyclone XD drill require a through-coolant spindle to use the internal coolant channels?
Yes, the drill is coolant fed through the shank, so the machine spindle must supply coolant through the tool holder for the internal passages to function.
Can the 15.50 mm double margin drill be used in a holder designed for standard single margin drills?
The double margin geometry needs a rigid, concentric holder; a standard single margin holder may not provide enough support and can reduce hole accuracy.
How can I confirm the 15.50 mm drill is cutting correctly after installation?
Check that the hole diameter stays within tolerance, the surface finish is consistent, and chips evacuate cleanly through the coolant fed flutes without packing.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
