M.A. Ford
M.A. Ford Cyclone Xd 8X Coolant Fed Double Margin Drill 15/32 11.9
A coolant-fed double-margin drill with 8x diameter capability for 15/32 inch and 11.9 mm holes
- 8× diameter reach enables deep-hole drilling
- Coolant-fed design improves chip evacuation and tool life
- Double-margin construction enhances hole straightness and surface finish
- 15/32 inch diameter suits precise fractional sizing
- 9 mm metric equivalent supports dual-system workflows
M.A. Ford Cyclone Xd Coolant Fed Drill
The M.A. Ford Cyclone Xd is an 8X coolant fed double margin drill built for high productivity drilling in demanding materials. It targets machinists and production engineers who need consistent hole quality and extended tool life when running deep holes with through coolant delivery.
Upgrade From Standard Twist Drills
This drill replaces conventional twist drills that lack internal coolant channels and double margin guidance. The jump is worth it when chip evacuation becomes a bottleneck or when hole straightness and surface finish must improve without reducing feed rates in tough alloys.
Verify Shank And Coolant Compatibility
Confirm your holder accepts the shank style and that your machine delivers coolant through the spindle at sufficient pressure for the 8X length to diameter ratio. Check that the 15/32 inch diameter and 11.9 mm metric equivalent match the hole specification before ordering.
Highlights
- 8× diameter reach enables deep-hole drilling
- Coolant-fed design improves chip evacuation and tool life
- Double-margin construction enhances hole straightness and surface finish
- 15/32 inch diameter suits precise fractional sizing
- 9 mm metric equivalent supports dual-system workflows
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
What shank size does the 15/32 inch drill need to fit my holder?
The drill has a 15/32 inch cutting diameter and a matching shank, so use a holder or collet that accepts 15/32 inch shanks for a secure fit.
How do I install the CXDCL4688AP drill and what step is often missed?
Insert the drill into a coolant-fed holder, tighten the collet evenly, then connect the coolant supply before starting the spindle; the step often missed is confirming coolant flow through the double-margin flutes.
When will the double-margin drill need replacement or reconditioning?
Replace or regrind the drill when the 15/32 inch cutting edges show wear, chipping, or when hole tolerance exceeds your spec, typically after the recommended tool-life interval for your material.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
