M.A. Ford
M.A. Ford Cyclone Xd 8X Coolant Fed Double Margin Drill 14.00 mm
Coolant-fed double-margin drill with 14.00 mm diameter for deep-hole accuracy
- Coolant-fed design evacuates chips for deeper holes
- Double-margin geometry improves hole accuracy and finish
- 8× diameter reach extends drilling capability
- 00 mm diameter suits precise machining tasks
- New M.A. Ford Cyclone Xd built for demanding applications
M.A. Ford Cyclone Xd 14.00 mm Drill
The M.A. Ford Cyclone Xd is a coolant-fed double margin drill with an 8x diameter-to-length ratio. It is engineered for production drilling in steel, stainless steel and high-temperature alloys where straightness and hole finish are critical. Machinists running CNC centres with through-spindle coolant gain the chip control this geometry provides.
Sustained-load behaviour with through coolant
Internal coolant channels deliver fluid to the cutting zone during deep-hole cycles, stabilising temperature at the margins. The double-margin design maintains alignment over the full 8x depth, reducing wander that typically appears in the second half of the cut. Consistent flow prevents built-up edge on gummy materials.
Shank and holder implications
The straight shank fits standard hydraulic, shrink-fit or collet holders without adapters. Double margins increase contact area, so holder runout must be kept low to avoid uneven wear. No external coolant plumbing is required when the machine supplies through-spindle pressure.
Highlights
- Coolant-fed design evacuates chips for deeper holes
- Double-margin geometry improves hole accuracy and finish
- 8× diameter reach extends drilling capability
- 00 mm diameter suits precise machining tasks
- New M.A. Ford Cyclone Xd built for demanding applications
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
How much heat does the 14.00 mm drill generate during continuous use?
The drill is designed with coolant-fed channels that carry heat away from the cutting zone, keeping the tool body cooler during extended drilling cycles.
What machine setup is required to run the coolant-fed drill?
You need a machine spindle with through-coolant capability and a compatible coolant delivery system to supply fluid through the drill’s internal passages.
Will the double-margin design work with older drill holders I already own?
The shank follows standard dimensions, so it fits conventional drill holders, but the double-margin geometry improves guidance in existing setups.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
