M.A. Ford
M.A. Ford Cyclone Xd 8X Coolant Fed Double Margin Drill 12.90 mm
Coolant-fed double-margin drill bores 12.90 mm holes with eight-times diameter reach
- Coolant-fed design clears chips efficiently during deep drilling
- Double margin construction improves hole straightness and surface finish
- 8X diameter capability reaches deeper holes in one pass
- Precise 12.90 mm diameter suits exacting machining tasks
- M.A. Ford manufacturing delivers reliable cutting performance
Cyclone Xd 8X Coolant-Fed Drill 12.90 mm
The M.A. Ford Cyclone Xd is a new coolant-fed double-margin drill with a 12.90 mm diameter. It is built for high-efficiency drilling in demanding materials where through-tool coolant delivery improves chip evacuation and tool life. The 8X designation indicates a deep-hole capability suited for production environments.
Suited for deep-hole production.
This drill suits CNC operators running deep-hole cycles in tough alloys who need the rigidity of double margins and internal coolant. It is not for hand-held drilling, low-rigidity machines, or jobs requiring a non-coolant solid carbide drill. Buyers without through-spindle coolant should look elsewhere.
12.90 mm cutting diameter
The 12.90 mm diameter is the critical specification that determines fit for the hole size required. Verify the nominal diameter matches the blueprint before ordering. The tool also carries a California Proposition 65 warning for chemicals known to cause cancer and reproductive harm.
Highlights
- Coolant-fed design clears chips efficiently during deep drilling
- Double margin construction improves hole straightness and surface finish
- 8X diameter capability reaches deeper holes in one pass
- Precise 12.90 mm diameter suits exacting machining tasks
- M.A. Ford manufacturing delivers reliable cutting performance
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
What machine spindle and coolant setup does the 12.90 mm Cyclone Xd 8X drill require?
The drill has a 12.90 mm diameter and is designed for coolant-fed operation; the machine spindle must accept that shank size and supply internal coolant for 8×D drilling.
What is the correct way to install this double-margin drill and what step is often missed?
Secure the 12.90 mm shank in a precision holder with minimal run-out, then activate internal coolant flow before the tool contacts the workpiece; skipping the pre-start coolant check is the common error.
When should the 12.90 mm Cyclone Xd drill be replaced or reconditioned?
Replace or regrind the drill when the double margins show wear, corner breakdown appears, or hole quality at 12.90 mm diameter falls outside tolerance.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
