M.A. Ford
M.A. Ford Cyclone Xd 8X Coolant Fed Double Margin Drill 12.80mm
Coolant-fed double-margin drill with 12.80 mm diameter for deep-hole drilling
- 8x diameter drilling depth for deep holes
- Coolant-fed design clears chips efficiently
- Double margin construction improves hole accuracy
- 80mm diameter suits precise applications
- New condition ensures full tool life
What this drill does
The M.A. Ford Cyclone Xd is a coolant-fed double-margin drill designed for deep-hole drilling at 8× diameter depth. It targets machine shops and production lines that need accurate, straight holes in tough materials without peck cycles. Buyers who need a standard twist drill for shallow holes or hand-held use will not benefit from this geometry.
Diameter that defines fit
The cutting diameter is 12.80 mm, and this single figure determines whether the tool matches the hole specification on the drawing. No other size or tolerance is offered in this listing, so the part either meets the print requirement or it does not.
Heat and power in the cut
Coolant delivered through the tool flushes chips and controls temperature at the cutting edges during extended 8×D cycles. The double-margin design stabilises the drill, reducing vibration and the spindle load that drives power consumption and noise. Without through-coolant capability on the machine, the thermal advantage cannot be realised.
Highlights
- 8x diameter drilling depth for deep holes
- Coolant-fed design clears chips efficiently
- Double margin construction improves hole accuracy
- 80mm diameter suits precise applications
- New condition ensures full tool life
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
What does the 12.80 mm diameter mean for hole size in a real machine?
The 12.80 mm diameter produces a hole of that exact size when the drill is run at proper speed and feed with coolant flowing through the tool.
What interface or standard governs the coolant-fed shank and what does it cap in practice?
The coolant-fed shank follows standard through-coolant holder requirements and caps maximum coolant pressure at the machine spindle seal rating.
What does the double-margin 12.80 mm body physically need to fit or mount in a holder?
A 12.80 mm cylindrical shank with through-coolant channels fits standard hydraulic or shrink-fit holders that accept that diameter.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
