M.A. Ford
M.A. Ford Cyclone Xd 8X Coolant Fed Double Margin Drill 11.30mm
Coolant-fed double-margin drill with 11.30 mm diameter for deep, precise holes
- Coolant-fed design delivers lubrication directly to the cutting zone
- Double margin construction improves hole straightness and surface finish
- 8X diameter capability enables deep-hole drilling in one pass
- 30 mm diameter suits precise metric hole requirements
- New condition ensures full factory performance and tool life
Cyclone Xd 8X coolant drill
The M.A. Ford Cyclone Xd is an 8X diameter coolant-fed double-margin drill built for deep-hole drilling in production environments. Its 11.30 mm cutting diameter targets manufacturers and machine shops that need consistent hole quality at extended lengths.
Double-margin design for stability
The double-margin geometry provides four-point land contact to improve hole straightness and surface finish while reducing vibration. Through-coolant delivery flushes chips from the flute space, which supports unattended cycling and protects the cutting edges during long runs.
Proposition 65 notice included
The supplier flags that this product contains a chemical known to the State of California to cause cancer and birth defects or other reproductive harm. Shops should review their handling procedures and safety-data sheets before putting the tool into service.
Highlights
- Coolant-fed design delivers lubrication directly to the cutting zone
- Double margin construction improves hole straightness and surface finish
- 8X diameter capability enables deep-hole drilling in one pass
- 30 mm diameter suits precise metric hole requirements
- New condition ensures full factory performance and tool life
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
What shank standard does the CXDCLM1130AP use and what maximum drill depth does the 8X designation allow?
The drill uses a straight cylindrical shank; the 8X rating means it can drill up to eight times its 11.30 mm diameter in a single pass.
What machine spindle and coolant system are required to run this 11.30 mm double-margin drill?
A rigid CNC or machining-centre spindle with through-spindle coolant delivery and sufficient torque for an 11.30 mm carbide drill.
How is the coolant-fed drill installed and what common setup error should be avoided?
Clamp the shank in a precision hydraulic or shrink-fit holder, align the coolant ports, and verify run-out; the frequent mistake is using a worn collet that lets the drill walk.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
