M.A. Ford
M.A. Ford Cyclone Xd 8X Coolant Fed Double Margin Drill 11.10 mm
Coolant-fed double-margin drill for 11.10 mm holes with 8x diameter depth capability
- 10 mm diameter suits precise hole sizes
- 8X drill length reaches deep features in one pass
- Coolant-fed design clears chips for longer tool life
- Double margin geometry improves hole straightness and finish
- M.A. Ford quality backs consistent performance in tough materials
Cyclone Xd 8X Coolant-Fed Drill
The M.A. Ford Cyclone Xd is a coolant-fed double-margin drill built for high-performance holemaking in demanding materials. It targets machinists and manufacturing engineers who need precise, deep holes with reliable chip evacuation and extended tool life.
11.10 mm diameter with 8X depth capability
The 11.10 mm cutting diameter supports production drilling at up to eight times the diameter, delivering strong headroom for deep-hole applications. Internal coolant channels flush chips efficiently, though the tool reaches its limit in extremely hard alloys or when machine rigidity cannot maintain the required feed rates.
Replaces standard twist drills in deep-hole work
This drill upgrades from conventional twist drills when hole depth exceeds typical three-to-five-diameter capacity and coolant-through capability is available. The jump is worth it for shops running repeated deep-hole cycles in tough materials where standard drills wander, overheat or break prematurely.
Highlights
- 10 mm diameter suits precise hole sizes
- 8X drill length reaches deep features in one pass
- Coolant-fed design clears chips for longer tool life
- Double margin geometry improves hole straightness and finish
- M.A. Ford quality backs consistent performance in tough materials
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
Will the 11.10 mm shank fit the collet on my existing drill press?
The drill has an 11.10 mm diameter shank; check your collet or chuck capacity to confirm a proper grip.
How can I verify the coolant-fed channels are flowing correctly after installation?
Run the machine at low speed with coolant on; steady fluid exit from both margins shows the internal passages are clear.
Does the box include any collets, holders or coolant adapters?
Only the Cyclone Xd 8X drill is supplied; collets, tool holders and coolant fittings must be sourced separately.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
