M.A. Ford
M.A. Ford Cyclone Xd 8X Coolant Fed Double Margin Drill 10.90 mm
Coolant-fed double-margin drill cuts 10.90 mm holes with eight-times diameter reach
- 8x diameter drilling depth for deep holes
- Coolant-fed design clears chips efficiently
- Double margin construction improves hole accuracy
- 90 mm cutting diameter matches precise specs
- New condition ensures full tool life
Cyclone Xd 8X Coolant-Fed Drill
The M.A. Ford Cyclone Xd 8X is a solid-carbide drill with a 10.90 mm diameter and double-margin geometry. Coolant-fed channels deliver lubricant directly to the cutting zone for controlled chip evacuation. It targets machinists producing deep, accurate holes in tough alloys where rigidity and heat management are critical.
8× Diameter Depth Constraint
The 8× diameter design limits practical drilling depth to roughly eight times the 10.90 mm size. Coolant pressure must stay sufficient to clear chips at that length without peck cycles. Rigidity drops beyond this ratio, so the tool is not suited for deeper holes or unstable setups lacking through-spindle coolant capability.
Replaces Standard Twist Drills
This drill replaces conventional twist drills that wander or overheat in deep-hole applications. The double-margin design improves hole straightness and surface finish, reducing secondary reaming operations. The jump is worth it when hole tolerance and tool life outweigh the higher per-unit cost of solid-carbide tooling.
Highlights
- 8x diameter drilling depth for deep holes
- Coolant-fed design clears chips efficiently
- Double margin construction improves hole accuracy
- 90 mm cutting diameter matches precise specs
- New condition ensures full tool life
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
Which Cyclone Xd 8X coolant-fed double margin drill should I choose for a 10.90 mm hole?
The CXDCLM1090AP is sized at 10.90 mm, so select this part when the drawing specifies that exact diameter and the 8× length-to-diameter ratio meets your depth requirement.
What does the 10.90 mm figure mean once the drill is in the spindle?
It is the cutting diameter; the tool will produce a 10.90 mm hole, and the double-margin design helps maintain size and straightness at the full 8× depth.
How does the coolant-fed interface affect performance in practice?
Internal coolant channels deliver fluid to the tip, improving chip evacuation and tool life when drilling deep holes at the 8× ratio.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
