M.A. Ford
M.A. Ford Cyclone Xd 8X Coolant Fed Double Margin Drill 10.40mm
A coolant-fed double-margin drill with 8× diameter depth capacity for 10.40 mm holes
- 8x diameter drilling depth for deeper holes
- Coolant-fed design improves chip evacuation and tool life
- Double margin construction enhances hole accuracy and finish
- 40mm diameter suits precise metric applications
- New condition ensures full manufacturer performance
10.40 mm Coolant-Fed Drill
The M.A. Ford Cyclone Xd is an 8X diameter coolant-fed drill with double margins, built for production drilling in tough alloys. Its through-coolant design delivers lubricant directly to the cutting zone for consistent chip evacuation. The 10.40 mm diameter suits precise hole-making in aerospace and automotive components. This tool targets machinists who need reliable deep-hole performance in a single pass.
Upgrade from Standard Twist Drills
Conventional twist drills often struggle with chip packing and heat buildup beyond 3X diameter, forcing peck cycles that slow production. The Cyclone Xd replaces those tools when hole depth reaches 8X diameter and coolant pressure is available. The jump is worth it for high-volume jobs where cycle time and tool life outweigh the higher initial cost. Shops without through-spindle coolant cannot use this drill effectively.
Limits of 8X Diameter Coolant Feed
The 8X length-to-diameter ratio demands stable workholding and rigid machine spindles to prevent deflection at the 10.40 mm size. Coolant pressure must stay within the tool holder and machine specifications to avoid seal failure or vibration. Chip control depends on correct feed rates; incorrect parameters can still cause packing despite the double-margin design. California Proposition 65 warnings apply to chemicals present in the tool coating.
Highlights
- 8x diameter drilling depth for deeper holes
- Coolant-fed design improves chip evacuation and tool life
- Double margin construction enhances hole accuracy and finish
- 40mm diameter suits precise metric applications
- New condition ensures full manufacturer performance
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
What shank diameter does the 10.40 mm Cyclone Xd drill need in the tool holder?
The drill has a 10.40 mm cutting diameter and a matching 10.40 mm cylindrical shank, so it requires a holder or collet that accepts a 10.40 mm shank.
How is the coolant-fed drill connected, and what step is often missed?
Connect the machine’s through-spindle coolant supply to the drill’s internal coolant channels; the step often missed is verifying that coolant pressure and flow reach the cutting edges before starting the cut.
When should the double-margin 10.40 mm drill be replaced?
Replace the drill when the double margins show visible wear, when hole diameter drifts beyond tolerance, or when thrust force and surface finish noticeably degrade during use.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
