M.A. Ford
M.A. Ford Cyclone Xd 8X Coolant Fed Double Margin Drill 10.30mm
Coolant-fed double-margin drill cuts 10.30 mm holes with 8× diameter reach
- Coolant-fed design delivers efficient chip evacuation during deep drilling
- Double-margin construction provides superior hole straightness and surface finish
- 8X diameter capability enables deep-hole drilling in a single pass
- Precise 10.30mm diameter ensures accurate hole sizing for critical applications
- M.A. Ford engineering delivers reliable performance in demanding materials
Cyclone Xd 8X Drill, 10.30 mm
The M.A. Ford Cyclone Xd is a solid-carbide drill built for high-performance holemaking. Its 8×D flute length and through-coolant design support deep drilling in a single pass. The double-margin geometry improves hole straightness and surface finish in tough alloys.
For CNC shops running deep-hole cycles
This drill suits production environments where coolant-fed tooling reduces cycle time and extends tool life. It is not suited for handheld use or machines without through-spindle coolant capability. Buyers needing a non-coolant or shorter-length drill should consider a different series.
Diameter: 10.30 mm
The cutting diameter is 10.30 mm, which determines the hole size produced. Verify that your programmed hole tolerance and holder capacity match this exact dimension before ordering.
Highlights
- Coolant-fed design delivers efficient chip evacuation during deep drilling
- Double-margin construction provides superior hole straightness and surface finish
- 8X diameter capability enables deep-hole drilling in a single pass
- Precise 10.30mm diameter ensures accurate hole sizing for critical applications
- M.A. Ford engineering delivers reliable performance in demanding materials
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
How do I install the 10.30 mm Cyclone Xd drill and what step is often missed?
Mount the drill in a rigid holder with through-coolant capability, then engage the coolant feed before starting the spindle — skipping the coolant-on step overheats the double-margin lands.
What maintenance or replacement will the 10.30 mm Cyclone Xd drill need later?
Re-grind the 10.30 mm cutting edges when flank wear reaches the margin width; the double-margin geometry can be restored only on a CNC grinder with the original point angle.
What limit appears first on the 10.30 mm Cyclone Xd drill under sustained use?
Margin land temperature rises until coolant film breaks down, causing built-up edge on the double margins — this thermal limit arrives before flank wear becomes critical.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
