M.A. Ford
M.A. Ford Cyclone Xd 8X Coolant Fed Double Margin Drill 10.00 mm
10.00 mm coolant-fed drill with double margins for deep, accurate holes
- 10 mm diameter suits precision holes
- 8× diameter depth reach extends drilling range
- Coolant-fed design clears chips efficiently
- Double-margin geometry improves hole straightness
- California Prop 65 warning informs safe handling
Drill for Deep-Hole Coolant Applications
The M.A. Ford Cyclone Xd is a coolant-fed double-margin drill built for 8x diameter depth capability. Its 10.00 mm cutting diameter suits precision hole-making in demanding materials. The design targets machine shops and production lines that require reliable chip evacuation and hole straightness.
Sustained Cutting Stability
Coolant delivered through the tool flushes chips continuously during long, deep cuts. The double-margin geometry guides the drill to maintain alignment over the full 8x depth. This reduces wandering and improves surface finish when cycle times extend beyond short bursts.
Machine and Toolholder Compatibility
Verify that your spindle and holder accept a 10.00 mm shank with internal coolant passages. Confirm the machine can supply coolant at the pressure and flow the drill requires. Check that the workpiece setup allows the full drill length without interference. California Proposition 65 warnings apply to this product.
Highlights
- 10 mm diameter suits precision holes
- 8× diameter depth reach extends drilling range
- Coolant-fed design clears chips efficiently
- Double-margin geometry improves hole straightness
- California Prop 65 warning informs safe handling
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
How much heat does the 10.00 mm Cyclone Xd drill generate during extended drilling cycles?
The 10.00 mm Cyclone Xd drill uses internal coolant feed to manage heat during continuous operation, keeping the cutting zone temperature lower than non-coolant drills.
What machine spindle and coolant system are required to run this 10.00 mm Cyclone Xd drill?
This drill requires a machine spindle capable of through-spindle coolant delivery and a compatible coolant filtration system to supply fluid through the internal channels.
Can the 10.00 mm Cyclone Xd drill be used in an older machining centre without through-spindle coolant?
Without through-spindle coolant capability the internal coolant channels cannot function, so the drill will not receive the cooling and chip evacuation it is designed for.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
