M.A. Ford
M.A. Ford Cyclone Xd 5X Solid Double Margin Drill 8.60Mm
8.60 mm solid double-margin drill delivers 5× diameter drilling depth for precise deep holes
- Precision drilling with 5x solid double margin design
- Accurate 8.60 mm diameter for consistent hole sizing
- Durable M.A. Ford construction for long tool life
- Cyclone Xd series engineered for high performance
- California Proposition 65 compliance disclosed for safety awareness
8.60 mm Cyclone Xd Drill
This M.A. Ford Cyclone Xd drill is a 5X solid double-margin cutting tool with an 8.60 mm diameter. It is built for high-performance drilling in a range of materials where rigidity and hole accuracy are required. The tool ships new directly from the manufacturer.
Suited for precision drilling operations
Machinists and engineers who need a sturdy, high-penetration drill for consistent hole quality will find this tool appropriate. It is not intended for applications requiring a different diameter, length, or flute geometry than the fixed specifications provide.
8.60 mm cutting diameter
The 8.60 mm diameter is the primary specification that determines fit for a specific hole size. Verify this exact measurement against your drawing or tap-chart requirements before purchasing.
Highlights
- Precision drilling with 5x solid double margin design
- Accurate 8.60 mm diameter for consistent hole sizing
- Durable M.A. Ford construction for long tool life
- Cyclone Xd series engineered for high performance
- California Proposition 65 compliance disclosed for safety awareness
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
What shank size must my drill chuck accept for the 8.60 mm Cyclone Xd bit?
The drill has an 8.60 mm diameter, so the chuck must open wide enough to grip a shank of that size.
Will the 8.60 mm Cyclone Xd drill produce accurate holes in a worn drill press spindle?
The solid double-margin design adds stability, helping the bit run true even if the spindle has some run-out.
How can I verify the 8.60 mm Cyclone Xd is cutting correctly after the first hole?
Measure the hole diameter; it should match the 8.60 mm spec, and the walls should show a clean, consistent finish.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
