M.A. Ford
M.A. Ford Cyclone Xd 5X Solid Double Margin Drill 4.00Mm pneumatic accessory
A 4.00 mm solid double-margin drill built for 5× diameter drilling depth
- Precision drilling with 5x diameter reach
- Solid double-margin design improves hole accuracy
- 00 mm diameter suits fine detail work
- Cyclone Xd geometry enhances chip evacuation
- New M.A. Ford quality for reliable performance
Cyclone Xd 5X solid double margin drill 4.00 mm
This M.A. Ford drill bit is a new pneumatic accessory built for precision hole-making in demanding materials. Its solid double margin design improves guidance and finish during extended drilling cycles. The tool suits machinists and maintenance teams who need consistent accuracy from a single high-performance cutter.
Sustained load behaviour
The double margin geometry maintains hole straightness and surface quality when the drill runs continuously through tough alloys. Chip evacuation remains steady because the flute form is matched to the 5× diameter depth capability. Operators see less wandering and reduced rework even during long production runs.
Thermals noise and power
Heat generated at the cutting edges is managed by the solid carbide construction and the margin layout that distributes contact forces. The tool runs without the vibration spikes that typically raise noise levels in less rigid drills. Power draw at the spindle stays predictable because the cutting action remains stable throughout the cut.
Highlights
- Precision drilling with 5x diameter reach
- Solid double-margin design improves hole accuracy
- 00 mm diameter suits fine detail work
- Cyclone Xd geometry enhances chip evacuation
- New M.A. Ford quality for reliable performance
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
Does the 4.00 mm drill generate noticeable heat or noise when run continuously in a pneumatic tool?
The solid double-margin design reduces vibration and heat buildup during extended drilling cycles, keeping the bit stable and the workpiece cooler.
What pneumatic tool or chuck is required to hold the 4.00 mm shank securely?
A standard pneumatic drill or rotary tool with a 4 mm collet or three-jaw chuck will grip the shank; no proprietary adapter is needed.
Will this Cyclone Xd bit work reliably in an older pneumatic drill that has some run-out?
The double-margin geometry improves guidance and tolerates moderate spindle run-out better than single-margin drills, reducing hole wander.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
