M.A. Ford
M.A. Ford Cyclone Xd 5X Solid Double Margin Drill 27/64
Solid double-margin drill bit, 27/64 inch, designed for 5× diameter depth drilling
- 5X diameter drilling depth reduces cycle time
- solid carbide construction resists wear in tough materials
- double margin design improves hole straightness
- 27/64 inch diameter suits precise hole sizing
- Cyclone Xd series built for high-performance drilling
Cyclone Xd 5X Drill
The M.A. Ford Cyclone Xd 5X is a solid double margin drill sized at 27/64 inch. It is built for machinists and maintenance teams who need accurate hole-making in steel and other tough alloys. The double margin design supports the tool during the cut to improve finish and dimensional control. This accessory fits directly into a standard drill chuck or tool holder.
Build integration
The drill requires a rigid machine spindle and a secure workholding setup to perform as intended. It frees the operator from frequent tool changes by maintaining size over long production runs. Coolant or cutting oil should be supplied to the point of cut for chip evacuation and temperature management. No special holders or adapters are needed beyond a standard chuck.
Thermals and power
Cutting heat is managed through proper coolant application and the tool's flute geometry. The solid carbide construction resists thermal deformation during continuous drilling cycles. Power draw at the spindle depends on the workpiece material, feed rate and depth of cut. The tool runs quietly when the machine spindle is balanced and the workpiece is clamped firmly.
Highlights
- 5X diameter drilling depth reduces cycle time
- solid carbide construction resists wear in tough materials
- double margin design improves hole straightness
- 27/64 inch diameter suits precise hole sizing
- Cyclone Xd series built for high-performance drilling
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
How deep can the 27/64 inch Cyclone Xd drill before chip evacuation becomes the limiting factor?
The 5X solid double-margin design supports drilling up to five times the diameter, so the 27/64 inch bit reaches its practical depth limit around 2-1/8 inches before chips pack the flutes.
Does the CXDSR4219AP run hot or loud during continuous CNC cycles?
The solid carbide construction and double margins dissipate heat evenly, keeping the 27/64 inch drill stable and quiet through full production shifts without thermal expansion issues.
What toolholder or spindle interface does the 27/64 inch Cyclone Xd require?
The straight-shank 27/64 inch drill fits any standard ER collet, Weldon flat holder or hydraulic chuck that accepts a 27/64 inch shank diameter.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
