M.A. Ford
M.A. Ford Cyclone Xd 5X Solid Double Margin Drill 19/32
Solid double-margin drill bit cuts 19/32 inch holes with five-times diameter reach
- Cyclone Xd design boosts drilling efficiency
- 5X solid construction extends tool life
- Double margin improves hole accuracy
- 19/32 inch diameter suits precise applications
- Prop 65 warning informs safe handling
Cyclone Xd 5X Drill 19/32
The M.A. Ford Cyclone Xd 5X is a solid double margin drill sized at 19/32. It is built for machinists and maintenance teams who need accurate holemaking in tough materials. The 5X design supports higher penetration rates than standard drills. This accessory fits directly into compatible drill chucks or tool holders.
Fixturing and chip control
The double margin construction guides the drill to maintain straightness and roundness without a separate pilot operation. It frees up cycle time by reducing the need for reaming or secondary finishing passes. Rigid workholding and through-coolant capability allow the margins to evacuate chips efficiently. The shank fits standard holders so no special adapters are required.
Stepping up from general-purpose drills
This drill replaces conventional two-flute bits when hole quality and tool life are critical. The jump is worth it for production runs where regrind intervals and scrap reduction outweigh the higher upfront cost. It is not suited for hand-held drilling or low-rigidity setups where runout cannot be controlled. Buyers needing larger diameters or different flute lengths will need other tooling.
Highlights
- Cyclone Xd design boosts drilling efficiency
- 5X solid construction extends tool life
- Double margin improves hole accuracy
- 19/32 inch diameter suits precise applications
- Prop 65 warning informs safe handling
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
How deep can the 19/32 inch Cyclone Xd 5X drill in one pass before chip packing becomes the limit?
The 5X diameter design allows drilling up to five times the 19/32 inch diameter in a single pass, so chip evacuation rather than flute length stops you first.
Does the solid double-margin construction run hotter or louder than a single-margin bit during all-day CNC cycles?
The double-margin design adds a second land for guidance, which reduces vibration and heat buildup compared with single-margin bits during continuous cutting.
What shank style does the 19/32 inch CXDSR5938AP need so it fits my holder without an adapter?
The CXDSR5938AP uses a straight round shank matching the 19/32 inch cutting diameter, so it fits standard drill chucks and collets directly.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
