M.A. Ford
M.A. Ford Cyclone Xd 5X Coolant Fed Double Margin Drill 9.70 mm
Coolant-fed double-margin drill cuts 9.70 mm holes five diameters deep
- 70 mm diameter enables precise hole sizing
- 5X coolant-fed design delivers efficient chip evacuation
- Double margin construction provides enhanced hole straightness
- Cyclone Xd geometry optimises cutting performance
- New condition ensures full factory specification compliance
M.A. Ford Cyclone Xd 5X Drill
The M.A. Ford Cyclone Xd 5X is a coolant-fed double margin drill designed for precise holemaking. It suits machinists and maintenance teams who need accurate drilling in metal components. The 9.70 mm diameter targets specific fastener or clearance sizes. This new tool arrives ready for industrial use.
Coolant-Fed Double Margin Limits
Coolant-fed operation requires a machine spindle and holder that deliver fluid through the tool. The double margin design improves hole straightness and finish but demands rigid setups to prevent deflection. Users without through-coolant capability cannot use this drill as intended. Chip evacuation relies entirely on that internal coolant pressure.
9.70 mm Diameter Decides Fit
The single specification that determines suitability is the 9.70 mm cutting diameter. The hole produced will match this size within the drill’s tolerance band. If the drawing calls for a different diameter, this drill cannot be substituted. Select it only when the finished hole must be 9.70 mm.
Highlights
- 70 mm diameter enables precise hole sizing
- 5X coolant-fed design delivers efficient chip evacuation
- Double margin construction provides enhanced hole straightness
- Cyclone Xd geometry optimises cutting performance
- New condition ensures full factory specification compliance
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
Which 9.70 mm Cyclone Xd 5X drill variant should I select?
The CXDCR 0970AP is the single listed version with a 9.70 mm diameter and 5X coolant-fed double-margin design.
What does the 9.70 mm diameter mean when the drill is in the machine?
It produces a 9.70 mm hole with the double-margin geometry guiding the cut and internal coolant flushing chips at depth.
What interface does the CXDCR 0970AP use and what does it limit?
The drill fits standard tool holders for 9.70 mm shanks, and the 5X length-to-diameter ratio caps the maximum drilling depth at five times the diameter.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
