M.A. Ford
M.A. Ford Cyclone Xd 5X Coolant Fed Double Margin Drill 9.20 mm
Coolant-fed double-margin drill for 9.20 mm holes, designed for five-times diameter depth
- 20 mm diameter fits precise hole requirements
- Coolant-fed design improves chip evacuation during drilling
- Double margin construction enhances hole straightness and finish
- 5X diameter length allows deeper drilling in one pass
- Cyclone Xd geometry optimises cutting performance in tough materials
Precision Drilling Tool
The M.A. Ford Cyclone Xd is a 9.20 mm diameter coolant-fed drill with a double margin design and 5x diameter flute length. It targets machinists and maintenance teams who need accurate deep-hole drilling in metal components. The tool arrives new and is intended for CNC or rigid machine setups where internal coolant delivery is available.
Coolant Dependency
This drill requires a machine spindle or holder that can supply coolant through the tool body at sufficient pressure. Without through-coolant capability the flutes cannot evacuate chips effectively at 5x depth, leading to heat buildup and potential breakage. The double margins improve guidance but do not replace the need for continuous fluid flow. Buyers without through-coolant equipment cannot use this tool as designed.
Installation Notes
Secure the drill in a precision collet or hydraulic holder with minimal runout to protect the margins. Verify that the coolant passages in the holder align with the drill’s inlet before starting the cycle. A common error is running the tool dry or with insufficient pressure, which causes immediate chip packing. Another frequent issue is using the drill in a handheld or low-rigidity setup where the 5x length amplifies vibration.
California Proposition 65
This product contains a chemical known to the State of California to cause cancer and birth defects or other reproductive harm. Handle with appropriate personal protective equipment and follow workshop safety procedures for metalworking fluids and swarf disposal. The warning applies to the drill as supplied and does not change the installation or operating requirements described above.
Highlights
- 20 mm diameter fits precise hole requirements
- Coolant-fed design improves chip evacuation during drilling
- Double margin construction enhances hole straightness and finish
- 5X diameter length allows deeper drilling in one pass
- Cyclone Xd geometry optimises cutting performance in tough materials
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
Should I choose the 9.20 mm size or another diameter?
Select the 9.20 mm drill when the hole must be exactly that diameter; other sizes are different tools and cannot cut a 9.20 mm hole.
What does the 5X designation mean for drilling depth on this 9.20 mm tool?
5X refers to a length-to-diameter ratio, so the flute length supports a hole roughly five times the 9.20 mm diameter in one plunge.
How does the coolant-fed design affect chip evacuation and tool life?
Internal coolant channels flush chips from the flutes and cool the cutting edges, which helps maintain performance in deep holes.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
