M.A. Ford
M.A. Ford Cyclone Xd 3X Solid Double Margin Drill 5/32
A 5/32 inch Cyclone Xd drill with solid double margins for accurate holes
- Cyclone Xd design drills three times faster
- Solid double margin construction improves hole straightness
- 5/32 inch diameter suits precise drilling tasks
- Manufactured by M.A. Ford for reliable performance
- Complies with California Proposition 65 chemical disclosure requirements
Cyclone Xd 3X Drill 5/32
The M.A. Ford Cyclone Xd 3X is a solid double margin drill built for precision holemaking in demanding materials. Its 5/32 inch diameter suits metalworking tasks requiring accurate sizing and finish. The 3X geometry supports efficient chip evacuation and tool life. This accessory targets professionals needing reliable performance in production environments.
Suited for tight-tolerance drilling
Machinists working with tough alloys or high-volume runs will value the double margin design for stability and hole quality. It is not intended for general-purpose wood or plastic drilling where standard twist drills suffice. Buyers who need larger diameters or coolant-fed tooling should look at other configurations. The 1562 series addresses specific ferrous and non-ferrous applications.
Handles 5/32 inch holes in hardened stock
The solid carbide construction provides rigidity for consistent results in materials up to high hardness ranges. It runs out when hole depths exceed the flute length or when intermittent cuts demand specialised coatings not present here. Operators gain headroom in feeds and speeds compared to standard two-flute drills. California Proposition 65 warnings apply for chemical exposure.
Highlights
- Cyclone Xd design drills three times faster
- Solid double margin construction improves hole straightness
- 5/32 inch diameter suits precise drilling tasks
- Manufactured by M.A. Ford for reliable performance
- Complies with California Proposition 65 chemical disclosure requirements
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
What size chuck or collet do I need to hold the 5/32 inch drill?
Use a chuck or collet that accepts a 5/32 inch shank; the drill diameter matches that size.
Will the 3X flute length reach through the same thickness of material as my old standard jobber drills?
The 3X design gives a shorter flute than a jobber, so it will not drill as deep in one pass.
How can I confirm the Cyclone Xd drill is cutting correctly after I start the hole?
Look for a straight, round hole with clean margins and consistent chip evacuation; the double margin design helps maintain alignment.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
