M.A. Ford
M.A. Ford Cyclone XD 3X Solid Double Margin Drill 21/32
Solid double-margin drill with 21/32 inch cutting diameter for precise holes
- 3X drilling depth reduces cycle time
- Double margin design improves hole straightness
- Solid carbide construction resists wear
- 21/32 inch diameter suits specific holes
- Cyclone XD coating extends tool life
Cyclone XD 3X drill for 21/32 inch holes
This M.A. Ford Cyclone XD 3X solid double margin drill cuts 21/32 inch diameter holes in metal workpieces. The double margin design supports the tool during deep cuts. It suits machinists and maintenance teams who need accurate hole size and finish. The tool arrives new and ready for the spindle.
Shank fits standard holders and frees chip space
The straight shank seats in common drill chucks and collets without adapters. Two margins guide the drill while leaving room for chips to escape along the flutes. This reduces packing in deep holes and cuts the need for frequent peck cycles. Coolant can reach the tip through the open flute area.
Solid carbide holds size under sustained load
Solid carbide construction resists deflection when the drill runs at full depth for long periods. The margins stay in contact with the hole wall, keeping diameter consistent from entry to breakthrough. Heat builds more slowly than in thinner web designs. The tool is not for hand-held use or non-rigid setups.
Highlights
- 3X drilling depth reduces cycle time
- Double margin design improves hole straightness
- Solid carbide construction resists wear
- 21/32 inch diameter suits specific holes
- Cyclone XD coating extends tool life
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
How deep can the 21/32 Cyclone XD 3X drill before chip evacuation limits sustained use?
The 3X solid double-margin design on this 21/32 drill is built to maintain hole straightness and chip flow at depths up to three times the diameter, so the practical limit under sustained use is the 3X depth capability.
Does the 21/32 Cyclone XD 3X run hot or draw extra power when drilling continuously?
The solid double-margin construction on this 21/32 drill reduces friction and heat build-up during continuous drilling, so it runs cooler and steadier than single-margin bits.
What shank size must my drill chuck accept for the 21/32 Cyclone XD 3X?
This 21/32 Cyclone XD 3X drill has a 21/32 inch cutting diameter, so your chuck must open at least that wide to hold the shank.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
