M.A. Ford
M.A. Ford Cyclone Xd 3X Coolant Fed Double Margin Drill 5.10mm
Coolant-fed double-margin drill for 5.10 mm holes with three-times diameter depth capability
- 10 mm diameter for precise hole sizing
- Coolant-fed design improves chip evacuation
- Double margin construction enhances hole straightness
- Cyclone Xd 3X geometry optimises cutting performance
- M.A. Ford manufacturing ensures professional-grade quality
Cyclone Xd 5.10mm Coolant-Fed Drill
The M.A. Ford Cyclone Xd is a solid-carbide drill with a 5.10mm diameter and a 3× diameter flute length. Coolant-fed channels run through the tool body to deliver lubricant directly to the cutting edges. Double-margin geometry improves hole straightness and surface finish in deep-hole applications. It is built for high-performance drilling in steels and difficult alloys.
Suited for CNC deep-hole drilling
This drill suits machine shops running CNC centres that have through-spindle coolant capability and need accurate holes at 3× diameter depth. It is not for hand-held drilling, machines without coolant feed, or jobs requiring longer reach or larger diameters than 5.10mm. The Prop 65 notice also means it is not for buyers who must avoid listed chemicals entirely.
Sustained cutting with internal coolant flow
Under continuous load the internal coolant passages flush chips and control temperature at the cutting zone, preventing built-up edge and thermal damage. The double margins maintain guidance and roundness throughout the full 3× depth without wandering. Stable torque and consistent hole quality are maintained cycle after cycle in production runs.
Highlights
- 10 mm diameter for precise hole sizing
- Coolant-fed design improves chip evacuation
- Double margin construction enhances hole straightness
- Cyclone Xd 3X geometry optimises cutting performance
- M.A. Ford manufacturing ensures professional-grade quality
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
What machine spindle and coolant system are needed to run this 5.10 mm Cyclone Xd drill?
It requires a CNC spindle with through-coolant capability and a holder that accepts a 5.10 mm shank.
Can I keep using my existing non-coolant drill holders with this tool?
No — the double-margin design needs pressurised coolant through the shank, so a through-coolant holder is mandatory.
How do I verify the drill is cutting correctly once installed?
Check for consistent chip evacuation, steady spindle load and hole diameter holding within tolerance at the 5.10 mm size.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
