M.A. Ford
M.A. Ford Cyclone Xd 3X Coolant Fed Double Margin Drill 19/32
Coolant-fed double-margin drill for 19/32 inch holes with three-times diameter reach
- Coolant-fed design clears chips efficiently during deep drilling
- 3× diameter capability handles deeper holes in a single pass
- Double-margin construction improves hole straightness and surface finish
- 19/32 inch diameter suits precise fractional-size applications
- California Proposition 65 warning notes chemical exposure risk
Cyclone Xd 3X Coolant-Fed Drill
The M.A. Ford Cyclone Xd is a coolant-fed double-margin drill built for high-performance holemaking. Its 3X geometry and through-tool coolant delivery target demanding production environments where chip evacuation and tool life are critical. The 19/32 inch diameter suits precise drilling operations in tough alloys and steels.
Suited for CNC shops running deep holes
This drill serves machinists who need reliable coolant-fed performance in a 19/32 size for consistent deep-hole results. It is not intended for manual drilling, handheld tools or applications without through-spindle coolant capability. Buyers needing a different diameter or a non-coolant design should consider other options.
Installs in compatible coolant-fed holders
The shank fits standard holders that accept the CXDCS5938AP series when through-coolant is available. Problems usually arise when the machine lacks adequate coolant pressure or the holder cannot seal the through-channel. Verify spindle coolant function and holder compatibility before use to avoid premature wear or breakage.
Highlights
- Coolant-fed design clears chips efficiently during deep drilling
- 3× diameter capability handles deeper holes in a single pass
- Double-margin construction improves hole straightness and surface finish
- 19/32 inch diameter suits precise fractional-size applications
- California Proposition 65 warning notes chemical exposure risk
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
What coolant system does the CXDCS5938AP Cyclone Xd 3X drill need to operate?
The drill is coolant-fed, so it requires a machine spindle or holder that delivers cutting fluid through its internal channels.
Can the 19/32 inch double-margin drill run in a standard 3-jaw chuck without runout issues?
The shank fits common holders, but the double-margin design works best in a precision collet or hydraulic chuck to maintain concentricity.
How do I verify the CXDCS5938AP is cutting correctly after installation?
Check for consistent chip evacuation, steady spindle load and hole diameter within tolerance at the 19/32 size.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
