M.A. Ford
M.A. Ford CXDSS 0780AP Cyclone Xd 3X Solid Double Margin Drill 7.80mm pneumatic accessory
7.80 mm Cyclone Xd solid double-margin drill for 3×D depth pneumatic drilling
- Solid double margin design improves hole straightness and finish
- Cyclone Xd 3X construction extends tool life in tough materials
- 80 mm diameter suits precise drilling applications
- M.A. Ford manufacturing ensures consistent performance
- California Proposition 65 notice included for safety compliance
M.A. Ford 7.80mm Cyclone Xd Drill
The M.A. Ford CXDSS 0780AP is a 7.80mm solid double margin drill from the Cyclone Xd 3X series. It is built as a pneumatic accessory for precision drilling tasks. The tool is supplied new and intended for professional workshop use.
Suited for accurate holemaking.
This drill suits operators who need a 7.80mm cutting diameter with the stability of a double margin design. It is not for buyers who require a different hole size or a drill without the enhanced guidance that double margins provide. The Prop 65 notice also means it is not for users seeking a product without listed chemical warnings.
7.80mm cutting diameter decides fit
The single specification that determines whether this is the correct part is the 7.80mm diameter. Match this exact size to the hole required by the job specification before ordering.
Highlights
- Solid double margin design improves hole straightness and finish
- Cyclone Xd 3X construction extends tool life in tough materials
- 80 mm diameter suits precise drilling applications
- M.A. Ford manufacturing ensures consistent performance
- California Proposition 65 notice included for safety compliance
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
Will the 7.80 mm shank fit the chuck on my older pneumatic drill?
The 7.80 mm shank fits any chuck that accepts at least that diameter; check your drill's maximum capacity before use.
How can I verify the Cyclone Xd 3X drill is cutting correctly after installation?
A clean, round hole with minimal burr and steady chip evacuation shows the double-margin geometry is working as designed.
Does the box include lubricant or only the 7.80 mm drill bit?
Only the solid double-margin drill is supplied; cutting fluid or coolant must be purchased separately.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
