M.A. Ford
M.A. Ford CXDSS 0750AP 7.50 mm Cyclone Xd 3X Solid Double Margin Drill
7.50 mm Cyclone Xd 3X solid double-margin drill for precise deep-hole drilling
- 50 mm diameter drills precise holes in one pass
- 3X flute geometry clears chips faster for smoother cuts
- Solid double margin design keeps the drill centred under load
- Cyclone Xd coating resists wear for longer tool life
- New M.A. Ford drill ready for immediate workshop use
7.50 mm Cyclone Xd Drill
The M.A. Ford CXDSS 0750AP is a solid double margin drill built for power and pneumatic tool users. Its 3X design targets controlled holemaking in production and maintenance environments where a 7.50 mm diameter is specified.
Capacity and headroom
The 7.50 mm cutting diameter sets the hole size this tool comfortably produces in a single pass. The double margin geometry adds stability in deeper cuts, but the fixed diameter means it cannot adapt when a different hole size is required.
Thermals noise and power draw
Cutting heat and sound levels depend on the host machine speed feed and workpiece material rather than the drill itself. Power draw is determined by the driving tool and the load applied during the cut.
Highlights
- 50 mm diameter drills precise holes in one pass
- 3X flute geometry clears chips faster for smoother cuts
- Solid double margin design keeps the drill centred under load
- Cyclone Xd coating resists wear for longer tool life
- New M.A. Ford drill ready for immediate workshop use
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
Will the 7.50 mm Cyclone Xd 3X drill fit the same chuck and collet setup I use for other 7.50 mm bits?
Yes, the 7.50 mm shank matches standard 7.50 mm chucks and collets, so it works with your existing holders without adapters.
How can I confirm the double-margin geometry is cutting correctly once installed?
Run a test hole in the target material; consistent chip formation, minimal vibration and a round hole within tolerance show the double margins are guiding properly.
Does the box include any coolant-fed adapters or only the solid carbide drill itself?
The package contains the CXDSS 0750AP solid carbide drill only; coolant-fed adapters, tool holders and collets are sold separately.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
