M.A. Ford
M.A. Ford CXDSR 1000AP Cyclone Xd 5X Double Margin Drill 10.00Mm
A solid double-margin drill with 5x diameter depth capacity for 10.00 mm holes
- 10 mm diameter fits precise hole sizes
- 5× length-to-diameter ratio reaches deeper holes
- Double margin design improves hole straightness
- Cyclone Xd geometry enhances chip evacuation
- New condition ensures full factory performance
10 mm Cyclone Xd drill bit
The M.A. Ford CXDSR 1000AP is a solid carbide drill bit with a 10.00 mm cutting diameter. It uses a 5× diameter flute length and a double-margin design for improved hole straightness. The tool is intended for high-performance drilling in a variety of materials.
Suited for precision holemaking.
Machinists needing accurate, deep holes in steel, stainless steel or cast iron will benefit from the double-margin geometry. Operations without rigid workholding or through-spindle coolant may not achieve the designed performance. Buyers who require a larger diameter or a different flute length should look at other options.
Fits standard toolholders; frees up cycle time
The straight shank fits common collets and hydraulic holders without special adapters. The 5× length reaches deeper features in a single pass, reducing the need for peck cycles. Ensure the machine spindle provides adequate run-out control for the 10 mm shank.
Highlights
- 10 mm diameter fits precise hole sizes
- 5× length-to-diameter ratio reaches deeper holes
- Double margin design improves hole straightness
- Cyclone Xd geometry enhances chip evacuation
- New condition ensures full factory performance
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
What drill chuck or collet size do I need for the 10.00 mm shank on this drill?
You need a chuck or collet that accepts a 10.00 mm shank. A standard 10 mm or 3/8 inch keyed or keyless chuck will hold it securely.
Will the double-margin design of this 1000AP drill cause issues if I use it in an older drill press with standard runout?
The double-margin design improves hole straightness and finish even on machines with moderate runout, but excessive spindle wobble will still reduce tool life.
After drilling, how can I confirm the Cyclone Xd 5X geometry is producing the expected hole quality?
Measure the finished hole diameter and check for a smooth, consistent surface finish without chatter marks. The double margins should leave a clean, round hole at the 10.00 mm size.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
