M.A. Ford
M.A. Ford CXDSR 0630AP Cyclone Xd 5X Double Margin Drill 6.30mm
A 6.30 mm solid double-margin drill designed for 5× diameter depth drilling
- 5x diameter drilling depth for deeper holes in one pass
- Double margin design improves hole straightness and surface finish
- Solid carbide construction resists wear in tough materials
- 30 mm diameter suits precise metric hole requirements
- Cyclone Xd geometry optimises chip evacuation and tool life
Drill for 6.30 mm holes
The M.A. Ford CXDSR 0630AP Cyclone Xd is a solid double-margin drill designed for producing accurate 6.30 mm diameter holes. Its 5X diameter flute length supports deeper drilling in a single pass. The tool is supplied new and carries California Proposition 65 warnings for cancer and reproductive harm.
Suited to CNC and precision drilling
Machinists needing tighter hole tolerance and better surface finish in difficult materials will benefit from the double-margin geometry that improves guidance. Operators restricted to standard single-margin drills or shorter flute lengths should consider other tooling.
6.30 mm cutting diameter
The 6.30 mm diameter is the primary specification that determines whether this drill matches the required hole size. Verify the diameter against the drawing before ordering.
Highlights
- 5x diameter drilling depth for deeper holes in one pass
- Double margin design improves hole straightness and surface finish
- Solid carbide construction resists wear in tough materials
- 30 mm diameter suits precise metric hole requirements
- Cyclone Xd geometry optimises chip evacuation and tool life
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
What size drill chuck or collet do I need for the 6.30 mm shank?
Use a chuck or collet that accepts a 6.30 mm shank; the drill’s shank diameter is 6.30 mm.
Can the 5× length and double-margin design run in the same holder as my shorter single-margin drills?
The 5× length increases overall reach, so verify your holder and machine clearance before swapping it with shorter drills.
How can I confirm the drill is cutting correctly after installation?
Check for a straight, correctly sized 6.30 mm hole with smooth walls and consistent chip evacuation during the first test cuts.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
