M.A. Ford
M.A. Ford CXDSR 0380AP Cyclone Xd 5X Double Margin Drill 3.80 mm
A 3.80 mm solid double-margin drill with 5× diameter flute length for deep-hole accuracy
- Solid double-margin design improves hole accuracy
- 5× diameter drilling depth in one pass
- 80 mm diameter suits precise pilot holes
- Cyclone Xd geometry reduces cutting forces
- California Proposition 65 warning for regulated chemicals
3.80 mm Cyclone Xd drill for high-precision holes
The M.A. Ford CXDSR 0380AP Cyclone Xd is a 5× solid double-margin drill with a 3.80 mm cutting diameter. It is made for machinists and maintenance teams who need accurate, deep holes in steel and alloy workpieces. The double-margin design improves hole straightness and surface finish during extended runs.
Prop 65 chemical notice for workplace safety
California Proposition 65 warnings state that this drill contains a chemical known to cause cancer and a chemical known to cause birth defects or other reproductive harm. No thermal, noise or power-draw data is supplied for the accessory itself, so normal-use characteristics cannot be described. Handlers should follow shop safety procedures and wear appropriate protection.
Direct-from-manufacturer supply simplifies
The accessory ships free and direct from M.A. Ford, reducing lead time and eliminating intermediate distributors. Buyers who need coated variants or different diameters must source those separately.
Highlights
- Solid double-margin design improves hole accuracy
- 5× diameter drilling depth in one pass
- 80 mm diameter suits precise pilot holes
- Cyclone Xd geometry reduces cutting forces
- California Proposition 65 warning for regulated chemicals
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
How do I install the 3.80 mm Cyclone Xd drill in my drill chuck and what step is often missed?
Insert the shank fully into the chuck jaws, then tighten securely. The step often missed is verifying the drill runs true with a dial indicator before cutting.
What maintenance or replacement will the 3.80 mm double margin drill need later?
The cutting edges will dull with use. Replace the drill when flank wear reaches the margin width or when hole quality drops below tolerance.
What limit appears first on the 3.80 mm Cyclone Xd drill under sustained use?
Heat buildup at the cutting lips is the first limit. It accelerates wear and can trigger the Proposition 65 warning chemicals in the tool coating.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
