M.A. Ford
M.A. Ford CXDCS 1210AP Cyclone Xd 12.10 mm Coolant-Fed Drill
Coolant-fed double-margin drill bit with 12.10 mm diameter for efficient chip evacuation
- 10 mm diameter suits precise hole-making
- Coolant-fed design clears chips from deep holes
- Double-margin geometry improves hole straightness
- Cyclone Xd coating resists wear in tough materials
- 3× flute length extends reach for deeper drilling
Cyclone Xd 12.10 mm coolant-fed drill
The M.A. Ford Cyclone Xd is a 12.10 mm diameter drill designed with internal coolant channels. Its double-margin geometry supports hole straightness and finish in production drilling. The tool targets machine shops running CNC cycles in steel, stainless alloys and cast iron where through-coolant capability is required.
Sustained cutting with through-coolant delivery
Coolant exits at the cutting lips to evacuate chips and control temperature during continuous 3×D drilling cycles. The double margins maintain alignment when the drill engages full diameter, reducing walk and preserving tolerance over long runs. Heat stays managed without external flood coolant interfering with the work zone.
Standard shank fits common holders
The drill mounts in any hydraulic, shrink-fit or collet holder that accepts its shank diameter. No special adapters or programmable peck cycles are needed to start the coolant flow. Operators must verify machine spindle coolant pressure meets the tool’s minimum requirement or chip packing will occur in deep holes.
Highlights
- 10 mm diameter suits precise hole-making
- Coolant-fed design clears chips from deep holes
- Double-margin geometry improves hole straightness
- Cyclone Xd coating resists wear in tough materials
- 3× flute length extends reach for deeper drilling
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
How much heat does the 12.10 mm Cyclone Xd generate when running continuously in a CNC machine?
The drill is designed for coolant-fed operation, so cutting fluid removes heat at the point of contact during extended cycles.
What toolholder or spindle interface is required to use the CXDCS 1210AP?
A coolant-through holder that matches the drill shank is needed to deliver fluid through the internal channels.
Will the 1210AP fit in an older 12 mm drill chuck without run-out issues?
The 12.10 mm diameter exceeds a standard 12 mm chuck capacity, so a larger or collet-style holder is required.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
